Modeling, analysis and design procedure of LCL filter for grid connected converters
- 1 June 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
This paper presents the mathematical deduction of models for LCL filters with and without the damping resistor, the criteria for designing LCL filter, a systematic procedure for designing LCL filter and experimental tests with an isolated load. Experimental tests demonstrate the relevance of propose procedure for the design of LCL filter. Usually, power inverter is the interface between renewable energy sources such as wind, solar and hydrogen fuel cells, and utility grid. However, high frequency PWM modulation generated in power inverter causes harmonic injection to the utility grid and reduces quality of the injected energy. LCL filter can reduce harmonic injection to the utility grid. Inappropriate design of LCL filter can cause excessive voltage attenuation at the output of the power inverter, resonances and oscillations that can increase total harmonic distortion, instability in power system and slow dynamic response.Keywords
This publication has 10 references indexed in Scilit:
- Two Degrees of Freedom Active Damping Technique for $LCL$ Filter-Based Grid Connected PV SystemsIEEE Transactions on Industrial Electronics, 2013
- Regions of Active Damping Control for LCL FiltersIEEE Transactions on Industry Applications, 2013
- Passive Filter Design for Three-Phase Inverter Interfacing in Distributed Generation2007
- Basic Criteria in Designing LCL Filters for Grid Connected Converters2006
- Active Harmonic FiltersProceedings of the IEEE, 2005
- Design and Control of an LCL-Filter-Based Three-Phase Active RectifierIEEE Transactions on Industry Applications, 2005
- Output filter design for a grid-interconnected three-phase inverter2003
- A control method to damp oscillation in the input LC filter2003
- Active power filters: A reviewIEE Proceedings - Electric Power Applications, 2000
- A review of active filters for power quality improvementIEEE Transactions on Industrial Electronics, 1999