Study of Alkaline/Polymer Flooding for Heavy-Oil Recovery Using Channeled Sandpacks
Authors:
- 16 May 2011
- journal article
- Published by Society of Petroleum Engineers (SPE) in SPE Reservoir Evaluation & Engineering
- Vol. 14 (03) , 310-319
Abstract
Summary: For heavy oils with viscosities ranging from 1000 to 10 000 mPa·s in western Canada, primary production and waterflood together can recover only 8–15% of original oil in place (OOIP) at their economic limits because of the adverse mobility ratio, severe water channeling, low reservoir pressure, and formation voidage. These heavy oils usually have a relatively high content of acids that can react with alkalis to form in-situ surfactants. The loosely consolidated sandstone formations in which these oils are deposited are characterized by high porosity, high permeability, and low reservoir temperature. These reservoir conditions are favorable for polymer application. Therefore, there is a potential to improve waterflood in these reservoirs by applying alkaline/polymer (A/P) flooding. This paper presents the results of a laboratory study of A/P flooding for heavy-oil recovery, including viscosity measurements, flood tests conducted in channeled sandpacks, residual-resistance-factor (FRR) determination, and residual-oil-distribution tests. A heavy oil with a viscosity of 1,202 cp and an acid number of 1.07 (mg of KOH/g of oil) and produced brine collected from a heavy-oil reservoir in Alberta are used in this study. We found that the distribution of the injected chemical solution within the high-permeability channels leads to the diversion of the subsequently injected chemical solution to low-permeability zones with higher oil saturation because of the formation of blockage in the channel zones. Consequently, pressure buildup during chemical-slug injection is the key to the improvement of displacement efficiency. Flood tests also show that A/P flooding is more efficient than either alkaline flooding or polymer flooding. The optimal formulation for the heavy oil used in this study is 0.4% NaOH + 0.2% Na2CO3 + 1000 mg/L polymer, with a tertiary oil recovery of 25–30% of OOIP above that from waterflooding. Analysis of the results of the residual-oil distributions in the channeled sandpacks at the end of A/P flooding show that A/P flooding can effectively improve the sweep efficiency of waterflooding for the heavy oil.Keywords
This publication has 21 references indexed in Scilit:
- High-Mobility-Ratio Waterflood Performance Prediction: Challenges and New InsightsSPE Reservoir Evaluation & Engineering, 2008
- Investigation of Foamy Oil Phenomena in Heavy Oil Reservoirs1999
- Application of Statistical Analysis to Optimize Reservoir PerformanceJournal of Canadian Petroleum Technology, 1997
- A Laboratory Study Of Caustic Flooding For Two Alberta Crude OilsJournal of Canadian Petroleum Technology, 1991
- Experiences With Waterflooding Lloydminster Heavy-Oil ReservoirsJournal of Petroleum Technology, 1982
- Recovery Mechanisms of Alkaline Flooding1981
- Flow of Oil-in-Water Emulsions Through Tubes and Porous MediaSociety of Petroleum Engineers Journal, 1979
- Recovery Of High-Viscosity Crudes By Polymer FloodingJournal of Canadian Petroleum Technology, 1977
- A Caustic Waterflooding Process for Heavy OilsJournal of Petroleum Technology, 1974
- Rheological Properties of Pseudoplastic Fluids in Porous MediaSociety of Petroleum Engineers Journal, 1967