An Investigation of Particle Size Distributions with Post Injection in DI Diesel Engines
- 12 April 2011
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In-cylinder emission control strategies, such as modifications of injection pressure and injection timing, have been used by researchers in order to reduce exhaust emissions and to comply with the legislation standards. Since some years ago post-injections have been studied and are well known as being efficient for soot emissions reduction. Although is well known that diesel gaseous and particle mass emissions have been reduced progressively over the last twenty years in response to the restrictive emission legislation and due to the application of new technologies The aim of this work is to help develop and understand the effect of the post-injection on diesel exhaust particle size distributions. The approach is to use a modern, well instrumented research engine equipped with a flexible high pressure fuel injection system. The results of this work are available to help provide guidelines for strategies to achieve reductions of the particle size distributions in diesel engines. The major improvements with the post-injection in the particle size distributions was in the nucleation mode with the use of close post-injection with a high fuel mass post-injected; in the case of the accumulation mode certain relation was founded with the use of close post-injections with high quantities of fuel mass post-injected. In all cases the use of two post-injections strategy shows similar trends than the use of a single post-injection strategy.Keywords
This publication has 22 references indexed in Scilit:
- Insights on postinjection-associated soot emissions in direct injection diesel enginesCombustion and Flame, 2008
- A Comprehensive Study of Diesel Combustion and Emissions with Post-injectionSAE International Journal of Advances and Current Practices in Mobility, 2007
- Effect of engine operating conditions on the size of primary particles composing diesel soot agglomeratesJournal of Aerosol Science, 2007
- Effects of current engine strategies on the exhaust aerosol particle size distribution from a Heavy-Duty Diesel EngineJournal of Aerosol Science, 2005
- Soot in diesel fuel jets: effects of ambient temperature, ambient density, and injection pressureCombustion and Flame, 2004
- Sensitivity of diesel engine thermodynamic cycle calculation to measurement errors and estimated parametersApplied Thermal Engineering, 2000
- Diagnosis of DI Diesel combustion from in-cylinder pressure signal by estimation of mean thermodynamic properties of the gasApplied Thermal Engineering, 1999
- Engines and nanoparticlesJournal of Aerosol Science, 1998
- Diesel Combustion Analysis Based on Two-Zone Model. (Comparison between Model Analysis and Experiment).JSME International Journal Series B, 1996
- Reducing Particulate and NOx Using Multiple Injections and EGR in a D.I. DieselSAE International Journal of Advances and Current Practices in Mobility, 1995