Effect of Temperature on Texture and Mechanical Properties of Deformed Mg–Bi Alloys
- 1 February 2025
- journal article
- research article
- Published by Pleiades Publishing Ltd in Physics of Metals and Metallography
- Vol. 126 (2) , 209-224
Abstract
The effect of temperature on texture, recrystallization volume fraction, and mechanical properties of hot rolled Mg–0.4 wt %Bi alloys has been studied. The alloys rolled at individual temperatures of 200 and 400°C, and subsequently annealed at 150°C for 10 min exhibit bimodal microstructure which possesses primarily the coarse deformed grains with basal texture and fine recrystallized grains with weak basal texture. Moreover, 〈c + a〉 non-basal dislocations are found to exist near the grain boundaries and these non-basal dislocations are expected to assist the nucleation of recrystallized grains with random orientations in the recrystallization process. The volume fraction of recrystallized region is found to increase with rolling temperature and during subsequent annealing period. However, when the alloy was rolled at temperatures of 400°C and annealed at 250°C for 10 min, entire region of matrix was recrystallized with weak basal formation. Segregation of Bi is found to exist only at a few grain boundaries. Furthermore, the latter alloy is observed to show better ductility properties than the former alloys.Keywords
This publication has 45 references indexed in Scilit:
- Mechanistic investigation of a low-alloy Mg–Ca-based extrusion alloy with high strength–ductility synergyActa Materialia, 2020
- Stable and metastable phase equilibria in binary Mg-Gd system: A comprehensive understanding aided by CALPHAD modelingJournal of Magnesium and Alloys, 2019
- Effects of Calcium on Strength and Microstructural Evolution of Extruded Alloys Based on Mg-3Al-1Zn-0.3MnMetallurgical and Materials Transactions A, 2019
- The synergy effect of fine and coarse grains on enhanced ductility of bimodal-structured Mg alloysJournal of Alloys and Compounds, 2019
- Ductility enhancement in Mg-0.2%Ce alloysActa Materialia, 2018
- Bake-hardenable Mg–Al–Zn–Mn–Ca sheet alloy processed by twin-roll castingActa Materialia, 2018
- Hot deformation behavior of Mg-4Li-1Al alloy via hot compression testsJournal of Alloys and Compounds, 2016
- Effect of Icosahedral Quasicrystalline Fraction and Extrusion Ratio on Microstructure, Mechanical Properties, and Anisotropy of Mg-Zn-Gd-Based AlloysMetallurgical and Materials Transactions A, 2013
- Compressive deformation behavior at room temperature – 773K in Mg–0.2mass%(0.035at.%)Ce alloyActa Materialia, 2008
- The texture and anisotropy of magnesium–zinc–rare earth alloy sheetsActa Materialia, 2007