Study on the contact performance of the variable hyperbolic circular arc tooth trace cylindrical gear with installation errors
Authors:
Open Access
- 8 May 2024
- journal article
- research article
- Published by Copernicus GmbH in Mechanical Sciences
- Vol. 15 (1) , 353-366
Abstract
Installation errors are important factor for the contact performance of the variable hyperbolic circular arc tooth trace (VH-CATT) cylindrical gear; the study of the relationship between installation errors and contact performances is beneficial for gear vibration and noise reduction. Firstly, based on the meshing theory, the tooth surface equation and contact ellipse of the VH-CATT cylindrical gear were deduced, and the tooth surface imprinting experiment was realized. Next, the tooth contact analysis model of the VH-CATT cylindrical gear was developed to investigate the influence of the installation errors on the elliptical contact area. Then, the calculation formulas of the tooth surface gap and contact point flexibility matrix were carried out to develop the load tooth contact analysis model of the VH-CATT cylindrical gear. Finally, the influence of the installation errors on the load distribution was investigated. Research shows that the elliptical contact area of the VH-CATT cylindrical gear is a line contact within a certain range and is located in the middle section of the tooth width. The elliptical contact area of the VH-CATT cylindrical gear increases or decreases rapidly when meshing in and out, and all the installation errors have a certain influence on the elliptical contact area, except for the center distance error. The single-tooth meshing area with the installation errors is greater than that of the ideal gear pair. The load distribution area with the installation errors deviates from the middle section, except for the center distance error. The installation rotation errors around the x and y axis have a certain influence on the maximum load of the single-tooth meshing area. The research results provide a basis for improving the bearing capacity of the VH-CATT cylindrical gear and optimizing the design.Keywords
Funding Information
- Natural Science Research Project of Guizhou Province (Qiankehejichu - ZK [2021] yiban 273)
This publication has 19 references indexed in Scilit:
- Kinematic calibration of over-constrained robot with geometric error and internal deformationMechanism and Machine Theory, 2023
- Mutually different tooth surface contact characteristics of a noncircular face gear with intersecting axesJournal of Mechanical Science and Technology, 2023
- A novel method for longitudinal modification and tooth contact analysis of non-circular cylindrical gearsJournal of Mechanical Science and Technology, 2022
- A study on tracking error based on mechatronics model of a 5-DOF hybrid spray-painting robotJournal of Mechanical Science and Technology, 2022
- Integrated wear prediction model for cylindrical gear with variable hyperbolic circular arc tooth trace under mixed elastohydrodynamic lubricationJournal of Mechanical Science and Technology, 2022
- Geometric contact characteristics and sensitivity analysis of variable hyperbolic circular-arc-tooth-trace cylindrical gear with error theory consideredXibei Gongye Daxue Xuebao/Journal of Northwestern Polytechnical University, 2022
- Meshing Contact Impact Properties of Circular Arc Tooth Trace Cylindrical Gear Based on Rotating Knife Dish Milling ProcessMathematical Problems in Engineering, 2021
- Comparison of spur, helical and curvilinear gear drives by means of stress and tooth contact analysesMeccanica, 2016
- Computerized design, simulation of meshing, and finite element analysis of two types of geometry of curvilinear cylindrical gearsComputer Methods in Applied Mechanics and Engineering, 2014
- A study on the effect of structure parameters on the dynamic characteristics of a PRRRP parallel manipulatorNonlinear Dynamics, 2013