Ultra wide band low noise amplifier with self-bias for improved gain and reduced power dissipation
Authors:
- 1 April 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1494-1498
Abstract
This paper presents ultra wide band low noise amplifier (LNA) with three stages for 1.9 to 8.2 GHz frequency band based on CMOS technology. In this LNA, first stage is designed on current reuse topology to achieve higher gain, while second stage is complementary push pull configuration in self biased state, which provides high gain and low noise contribution and the third stage is common source stage. This paper proposes two different designs. These designs are optimized for different set of parameters, which makes them suitable for two different categories of applications. The first design with single power source, is able to achieve gain of 21dB with average noise figure of 1.41 dB. Also, 3rd order intercept point (IIP3) and 1-dB compression point are 6 dBm and -17 dBm respectively. While second design achieves reduction in the power dissipation and enhances input output impedance matching. Power dissipation of the second design is 4.1 mW only. Both Ultra Wide Band Low Noise Amplifiers (UWBLNA) are designed and simulated using TMSC 130 nm CMOS technology.Keywords
This publication has 10 references indexed in Scilit:
- A new pole-zero technique for reducing thermal noise to design a very low noise figure UWB LNA2014
- 3.1–10.6GHz ultra-wideband LNA design using dual-resonant broadband matching techniqueAEU - International Journal of Electronics and Communications, 2013
- A low power and high linearity UWB low noise amplifier (LNA) for 3.1–10.6 GHz wireless applications in 0.13 μm CMOS processMicroelectronics Journal, 2013
- High linearity technique for ultra-wideband low noise amplifier in 0.18μm CMOS technologyAEU - International Journal of Electronics and Communications, 2012
- A 0.9-V, 7-mW UWB LNA for 3.1–10.6-GHz wireless applications in 0.18- CMOS technologyMicroelectronics Journal, 2011
- Complementary UWB LNA Design Using Asymmetrical Inductive Source DegenerationIEEE Microwave and Wireless Components Letters, 2010
- Low-voltage low-power CMOS RF low noise amplifierAEU - International Journal of Electronics and Communications, 2009
- High-Voltage-Gain CMOS LNA For 6–8.5-GHz UWB ReceiversIEEE Transactions on Circuits and Systems II: Express Briefs, 2008
- Very low-power CMOS LNA for UWB wireless receivers using current-reused topologySolid-State Electronics, 2008
- An Ultra-Wide-Band 0.4–10-GHz LNA in 0.18-$\mu$m CMOSIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2007