Seismic Response Evaluation of High-Steep Slopes Supported by Anti-Slide Piles with Different Initial Damage Based on Shaking Table Test
Open Access
Abstract
In order to study the instability development process of the slope reinforced by anti-slide piles under earthquake conditions, the dynamic response characteristics of the slope are usually taken as the main characteristics, and the model test and numerical simulation are the main research methods. In this paper, a shaking table model test is designed and completed to investigate the influence of anti-slide piles with different initial damage on the failure mode of high and steep slope under earthquake conditions. The changes in velocity, strain and natural frequency during slope vibration are tested in combination with cloud maps when sinusoidal waves of different accelerations with a peak value of 5 Hz are applied. Thus, the differences of slope failure development process and dynamic response characteristics are obtained. The experimental results show that the anti-slide pile with different initial damage has obvious influence on the slope instability process. Under the condition of good anti-slide pile quality, the failure development of the slope behind the pile is limited to soil sliding on top of the slope, slope sliding and overburden sliding; the front slope foot of pile mainly forms shear belt and local sliding. With the decrease in the initial mass of the anti-slide pile, the slope failure develops into topsoil sliding, slope sliding and deep integral sliding; analogously, the failure of the slope in front of the pile develops into a whole slip along the slip belt. The natural frequency cloud map can directly reflect the damage location of the slope, and the frequency change rate is positively correlated with the cumulative shear strain. It shows that the macro-failure characteristics of the model slope change well when the natural frequency is used as the sensitive index to measure the influence of vibration on the model slope. The threshold value of the natural frequency change rate can distinguish different development stages of the slope; 1% is the threshold value of stage II, and 1.5% is the threshold value of stage III.Keywords
Funding Information
- Sichuan Science and Technology Program (2018GZ0057, 51878577)
- The National Natural Science Foundation of China (2018GZ0057, 51878577)
This publication has 24 references indexed in Scilit:
- Lateral Behavior of Piled Bridge Foundation and Stabilizing Piles on Steep SlopeKSCE Journal of Civil Engineering, 2019
- Seismic damage mechanism of bedrock and overburden layer slope reinforced by sheet pile wallJournal of Geophysics and Engineering, 2019
- Dynamic response of a slope reinforced by double-row anti-sliding piles and pre-stressed anchor cablesJournal of Mountain Science, 2019
- Examining dynamic soil pressures and the effectiveness of different pile structures inside reinforced slopes using shaking table testsSoil Dynamics and Earthquake Engineering, 2019
- Seismic response of a sheet-pile wall with anchoring frame beam by numerical simulation and shaking table testSoil Dynamics and Earthquake Engineering, 2018
- Seismic stability of slopes reinforced with sleeved and unsleeved pilesEuropean Journal of Environmental and Civil Engineering, 2018
- Numerical Investigation of Seismically Induced Rock Mass Fatigue as a Mechanism Contributing to the Progressive Failure of Deep-Seated LandslidesRock Mechanics and Rock Engineering, 2015
- Optical Fiber Bragg Grating Sensor Using Cantilever Beam of Qual Strength for Slope Sliding Displacement MonitoringACTA PHOTONICA SINICA, 2015
- Centrifuge Modeling of the Seismic Performance of Pile-Reinforced SlopesJournal of Geotechnical and Geoenvironmental Engineering, 2014
- Centrifuge model test study on pile reinforcement behavior of cohesive soil slopes under earthquake conditionsLandslides, 2013