Simulation of the Melting Behavior of the UO2-Zircaloy Fuel Cladding System by Laser Heating
Authors:
Open Access
- 7 September 2022
- journal article
- research article
- Published by Taylor & Francis in Nuclear Science and Engineering
- Vol. 197 (3) , 351-363
Abstract
The current research focuses on laser melting and successive analysis of laboratory-scale uranium dioxide nuclear fuel samples in direct contact with Zircaloy-4 cladding. The goal was to characterize the melted and refrozen interfaces, in particular, observing local changes of the melting point and interdiffusion of fuel and cladding materials under inert gas (Ar), in the presence of hydrogen (Ar + 6% H2) or in air. Results obtained by laser heating UO2 pellets clad in a Zircaloy ring were interpreted in light of reference tests performed on pellets in which UO2 and zirconium were blended in a series of given compositions. The sample composition was analyzed by scanning electron microscopy to verify the occurrence of diffusion and segregation phenomena during the laser-heating cycles. Laser-melting experiments were performed on pellets of uranium dioxide clad in Zircaloy-4 rings to simulate the configuration of a light water reactor fuel rod. Under inert gas, the material interdiffusion resulted in consistent melting point depression (of up to 200 K below the melting point of pure UO2) at the interface between the fuel and the cladding. Experiments carried out in the presence of H2 displayed a more limited effect on the melting temperature, but they resulted in a remarkable embrittlement of the whole structure, with large fragmentation of the Zircaloy cladding. This was probably due to the formation of brittle and highly volatile Zr hydrides. The observed melting point decrease was even more pronounced (up to over 400 K) under air in uranium-rich samples, due to the change in the stoichiometry of UO2 in UO2+x.Keywords
This publication has 15 references indexed in Scilit:
- Assessment of solid/liquid equilibria in the (U, Zr)O2+y systemJournal of Nuclear Materials, 2017
- The ASTEC Integral Code for Severe Accident SimulationNuclear Technology, 2009
- New techniques for high-temperature melting measurements in volatile refractory materials via laser surface heatingReview of Scientific Instruments, 2008
- Consequences of material effects on in-vessel retentionNuclear Engineering and Design, 2007
- Core loss during a severe accident (COLOSS)Nuclear Engineering and Design, 2005
- Current knowledge on core degradation phenomena, a reviewJournal of Nuclear Materials, 1999
- In-vessel coolability and retention of a core meltNuclear Engineering and Design, 1997
- Radiance temperatures (in the wavelength range 523?907 nm) of group IVB transition metals titanium, zirconium, and hafnium at their melting points by a pulse-heating techniqueInternational Journal of Thermophysics, 1994
- Hydrides and delayed hydrogen cracking in zirconium and its alloysInternational Metals Reviews, 1983
- The kinetics of the uranium dioxide—Zircaloy reactions at high temperaturesJournal of Nuclear Materials, 1979