Preparation and Characterization of New Anodes Based on Ti Mesh for Direct Methanol Fuel Cells
Authors:
- 1 January 2006
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 153 (8) , A1575-A1583
Abstract
A novel anode structure based on Ti mesh for the direct methanol fuel cell (DMFC) has been prepared by thermal deposition of ∼5μm∼5μm PtRuO2PtRuO2 catalyst layer on ∼50μm∼50μm Ti mesh. The preparation procedures and the main characteristics of the anode were studied by half-cell testing, scanning electron microscopy analysis, energy-dispersive X-ray measurement, and single-cell testing. The optimum calcination temperature is 450°C450°C , calcination time is 90– 120min120min , PtRuO2PtRuO2 catalyst loading is 5.0mgcm−25.0mgcm−2 , Pt precursor concentration range of solution is 0.14– 0.4M0.4M , and solution aging time is 1 day. The performances of the anodes prepared using the solution kept within 20 days showed no significant difference. When it was used in DMFC feed with low-concentration methanol solution at 90°C90°C , this new anode shows better performance than that of the conventional anode, because its thin hydrophilic structure is a benefit to the transport of methanol and carbon dioxide. However, due to its opening structure, when higher concentration methanol was employed, the performance of the cell with new anode became worse.Keywords
This publication has 21 references indexed in Scilit:
- In situ visualization study of CO2 gas bubble behavior in DMFC anode flow fieldsJournal of Power Sources, 2005
- Preparation of Direct Methanol Fuel Cells by Defined Multilayer StructuresJournal of the Electrochemical Society, 2005
- On the question of MEA preparation for DMFCsJournal of Power Sources, 2004
- Nafion Membrane Coated with Sulfonated Poly(vinyl alcohol)-Nafion Film for Direct Methanol Fuel CellsElectrochemical and Solid-State Letters, 2002
- Influence of Ionomer Content in Catalyst Layers on Direct Methanol Fuel Cell PerformanceJournal of the Electrochemical Society, 1999
- Limiting current behaviour of the direct methanol fuel cellElectrochimica Acta, 1999
- A liquid-feed solid polymer electrolyte direct methanol fuel cell operating at near-ambient conditionsJournal of Power Sources, 1998
- Characterization of DSA type electrodes prepared by rapid thermal decomposition of the metal precursorElectrochimica Acta, 1998
- High Performance Direct Methanol Polymer Electrolyte Fuel CellsJournal of the Electrochemical Society, 1996
- Thin-film catalyst layers for polymer electrolyte fuel cell electrodesJournal of Applied Electrochemistry, 1992