Perfect Torque Compensation of Planar 5R Parallel Robot in Point-to-Point Motions, Optimal Control Approach
- 13 October 2020
- journal article
- research article
- Published by Cambridge University Press (CUP) in Robotica
- Vol. 39 (7) , 1163-1180
Abstract
SUMMARY: In this paper, a new approach is presented for perfect torque compensation of the robot in point-to-point motions. The proposed method is formulated as an open-loop optimal control problem. The problem is defined as optimal trajectory planning with adjustable design parameters to compensate applied torques of a planar 5R parallel robot for a given task, perfectly. To illustrate the effectiveness of the approach, the obtained optimal path is used as the reference command in the experiment. The experimental outputs show that the performance index has been reduced by over 80% compared to the typical design of the robot.Keywords
This publication has 32 references indexed in Scilit:
- Optimal design of a 2-DOF pick-and-place parallel robot using dynamic performance indices and angular constraintsMechanism and Machine Theory, 2013
- Trajectory optimization of nonholonomic mobile manipulators departing to a moving target amidst moving obstaclesActa Mechanica, 2013
- Trajectory Planning in RoboticsMathematics in Computer Science, 2012
- Maximum DLCC of Spatial Cable Robot for a Predefined Trajectory Within the Workspace Using Closed Loop Optimal Control ApproachJournal of Intelligent & Robotic Systems, 2011
- Par2: a spatial mechanism for fast planar two-degree-of-freedom pick-and-place applicationsMeccanica, 2011
- Maximum payload path planning for redundant manipulator using indirect solution of optimal control problemThe International Journal of Advanced Manufacturing Technology, 2008
- Optimum dynamic balancing of planar parallel manipulators based on sensitivity analysisMechanism and Machine Theory, 2006
- Kinematics, singularity and workspace of planar 5R symmetrical parallel mechanismsMechanism and Machine Theory, 2006
- Minimum cost trajectory planning for industrial robotsEuropean Journal of Mechanics - A/Solids, 2004
- Conceptual Design and Dimensional Synthesis of a Novel 2-DOF Translational Parallel Robot for Pick-and-Place OperationsJournal of Mechanical Design, 2003