Interference Test Pressures of a Reservoir with Vertical and Horizontal Wells

Authors:

Abstract
Over the years, interference test analysis has become a veritable analytical tool in reservoir characterization of most brown fields. At interference the area between the wells has been adequately swept. Therefore, results obtained from interference data analysis show a better reservoir representation as compared to that obtained from single well test. This study presents an analysis of interference test data of horizontal and vertical wells for various well spacing using Malekzadeh's model. Malekzadeh assumed an isotropic reservoir condition. For the fact that anisotropy has a major effect on the pressure transient responses of horizontal well, the results of Malekzadeh have limited applicability. Thus, in an attempt to alleviate this limitation, this analytical study was borne. The reservoir model used in this study is assumed to be anisotropic, laterally infinite and bounded at its top and bottom. Skin and wellbore storage effects are not considered. For proper analysis, three cases are considered: (1) an observation horizontal well and active vertical well, (2) observation vertical well and (3) active horizontal well and an active observation vertical well and an active horizontal well. Type curves are generated for each case. Our results show a slope of 1.1513/cycle for Cases 1 and 2 and a slope of 2.303/cycle for Case 3 at interference for late time flow regime. However, a check on the effect of anisotropy reveals that directional permeabilities bring about a slightly higher bottomhole responses for late-time flow regimes. For pressure to be felt by adjacent wells, an enomous time is sometime needed pending on the location of the observation well. In conclusion, our findings show that anisotropy strongly affects interfering pressures between wells.