Development of a stream function-upper bound analysis applicable to the process of plate rolling
- 8 August 2016
- journal article
- research article
- Published by Emerald Publishing in Multidiscipline Modeling in Materials and Structures
- Vol. 12 (2) , 254-274
Abstract
Purpose: – The purpose of this paper is to develop a mathematical solution to estimate the deformation pattern and required power in cold plate rolling using coupled stream function method and upper bound theorem. Design/methodology/approach: – In the first place, an admissible velocity field and the geometry of deformation zone are derived from a new stream function. Then, the optimum velocity field is obtained by minimizing the corresponding power function. Also, to calculate the adiabatic heating during high speed rolling operations, a two-dimensional conduction-convection problem is sequentially coupled with the mechanical model. To verify the predictions, rolling experiments on aluminum plates are conducted and also, a finite element analysis is performed by Abaqus/Explicit. The predicted deformation zone is then compared with the experimentally measured region as well as with the results of the finite element analysis. Findings: – The results show that the predicted deformation zone and the temperature distribution fit reasonably with the experimental data while much lower computational cost needs comparing to the fully finite element analysis. Originality/value: – A new stream function is proposed to properly describe the velocity field and deformation pattern during plate rolling considering the neutral point. Furthermore, the employed algorithm can be simply coupled with the thermal finite element analysis.Keywords
This publication has 17 references indexed in Scilit:
- Thermo‐mechanical analysis of cold extrusion process using stream function and finite element methodsMultidiscipline Modeling in Materials and Structures, 2013
- Investigation of Single Pass Shape Rolling Using an Upper Bound MethodJournal of Materials Engineering and Performance, 2009
- Modelling of microstructure evolution during hot rolling of AA5083 using an internal state variable approach integrated into an FE modelMaterials Science and Engineering: A, 2004
- An upper bound method for analysis of three-dimensional deformation in the flat rolling of barsInternational Journal of Mechanical Sciences, 2002
- An investigation into the plastic deformation behavior at the roll gap during plate rollingJournal of Materials Processing Technology, 1999
- Analysis of the variation of the cold-rolling characteristics of rolling force, strip shape, stress and temperature, for a three-dimensional stripJournal of Materials Processing Technology, 1995
- Analysis of sandwich sheet rolling by stream function methodInternational Journal of Mechanical Sciences, 1995
- Mathematical Simulation of Clad Sheet Rolling and Sandtvich Sheet HollingCIRP Annals, 1992
- The use of dual-stream functions in the analysis of three-dimensional metal forming processesInternational Journal of Mechanical Sciences, 1991
- Deformation processingMetallurgical Transactions, 1973