Optimum parameters for humic acid removal and power production by Al–air fuel cell electrocoagulation in synthetic wastewater
Open Access
- 29 November 2021
- journal article
- research article
- Published by IWA Publishing in Water Science & Technology
- Vol. 85 (1) , 174-187
Abstract
Although humic acid (HA) is a complex natural organic matter, it can potentially harm the environment and human health. In this study, aluminum–air fuel cell electrocoagulation (AAFCEC) was used to remove HAs from water while generating electricity. Initial pH, electrolyte concentration, HA concentration electrode distance and external resistance were investigated to determine the power generation and removal efficiency. The results showed that the better performance of power generation has been acquired in the alkaline solution and larger electrolyte concentration and short electrode distance. Further, Al–Ferron complexation timed spectrophotometry was used to determine the Al speciation distribution in the solution under different parameters. The power density of the cell reached 313.47 mW/cm2 for the following conditions: 1 g/L NaCl concentration, 3 cm electrode distance, 20 Ω external resistor, and pH 9. After about an hour of electrolysis, the optimum removal rate of HA was above 99%. The results demonstrated that the AAFCEC is an efficient and eco-friendly water treatment process, and it could be further developed and disseminated in the rural areas and households.Keywords
All Related Versions
Funding Information
- University Natural Science Research Project of Anhui Province (NO.KJ2019A0756)
- Research Project Fund of Anhui Jianzhu University (NO.2018QD08)
- Key Research and Development Program of Anhui Province (201904a07020070)
- Natural Science Foundation of Anhui Province (NO. 1908085QE249)
This publication has 54 references indexed in Scilit:
- Electrochemical polarization and corrosion behavior of Al–Zn–In based alloy in acidity and alkalinity solutionsInternational Journal of Hydrogen Energy, 2013
- Effects of acidity and alkalinity on corrosion behaviour of Al–Zn–Mg based anode alloyJournal of Power Sources, 2013
- The properties and filtration efficiency of activated carbon polymer composite membranes for the removal of humic acidDesalination, 2013
- Effect of aluminum speciation on arsenic removal during coagulation processSeparation and Purification Technology, 2012
- Study on the influence of humic acid of different molecular weight on basic ion exchange resin's adsorption capacityChinese Chemical Letters, 2009
- The effects of alternating current electrocoagulation on dye removal from aqueous solutionsChemical Engineering Journal, 2009
- Electricity generation at high ionic strength in microbial fuel cell by a newly isolated Shewanella marisflavi EP1Applied Microbiology and Biotechnology, 2009
- Effect of initial pH on the removal of humic substances from wastewater by electrocoagulationSeparation and Purification Technology, 2008
- Relative importance of hydrolyzed Al(III) species (Ala, Alb, and Alc) during coagulation with polyaluminum chloride: A case study with the typical micro-polluted source watersJournal of Colloid and Interface Science, 2007
- Speciation stability of inorganic polymer flocculant–PAClColloids and Surfaces A: Physicochemical and Engineering Aspects, 2004