Problems of shock temperature measurements for metals by using optical radiometry method
Authors:
- 1 November 2001
- journal article
- research article
- Published by Taylor & Francis in High Pressure Research
- Vol. 21 (3-4) , 183-214
Abstract
Several problems encountered in shock temperature measurements for metals using optical radiometry were discussed in detail. The influences of the driver/film gap upon the observed interface temperature history were formulated analytically, and the temperature relaxation behaviors at the film/window interface were also characterized. We found that the energy deposition at the driver/film gap would influence to varied degrees the film/window interface temperature profile unless the film deposited on the window can be regarded to have an infinite thickness. Modeling calculations showed that at shock pressures of a few megabars, the observed interface temperature of iron would be at least 300–600 K higher, relative to the prediction from the Grover model, provided that the gap and film were both 1 ∼ 2 pm thick. Additionally, a metal-plate sample was used to measure a reliable shock temperature based on one-dimensional heat conduction model for the plate-sample(driver)/ pm-gap/window setup we proposed. Preliminary measured results for a meteoritic iron sample (kamacite, with Fe 93.65 wt.% and Ni 6.35 wt.%) using a disc sample showed that this method was practical and effective. Finally, the “heat-resistance model” proposed by Tang et al., and the experimental measurement of the heat conductivity for a transparent window (sapphire or LiF crystal) at megabar shock pressures were discussed and commented on as well.Keywords
This publication has 14 references indexed in Scilit:
- Composition and temperature of Earth's inner coreJournal of Geophysical Research, 1997
- Thermal properties of iron at high pressures and temperaturesPhysical Review B, 1996
- Temperatures in Earth's Core Based on Melting and Phase Transformation Experiments on IronScience, 1994
- Shock temperatures and melting of iron at Earth core conditionsPhysical Review Letters, 1993
- Temperatures in the Earth's core from melting-point measurements of iron at high static pressuresNature, 1993
- Issues concerning shock temperature measurements of iron and other metalsJournal of Geophysical Research, 1990
- Shock temperature measurements for metalsHigh Pressure Research, 1990
- The Melting Curve of Iron to 250 Gigapascals: A Constraint on the Temperature at Earth's CenterScience, 1987
- Phase transitions, Grüneisen parameter, and elasticity for shocked iron between 77 GPa and 400 GPaJournal of Geophysical Research, 1986
- Thermal relaxation at interfaces following shock compressionJournal of Applied Physics, 1974