Effect of “ColdArc” WAAM Regime and Arc Torch Weaving on Microstructure and Properties of As-Built and Subtransus Quenched Ti-6Al-4V
Open Access
Abstract
Defect-free thin-walled samples were built using wire arc additive manufacturing (WAAM) combined with the “coldArc” deposition technique by feeding a Ti-6Al-4V welding wire and using two deposition strategies, namely with and without the welding torch weaving. The microstructures formed in these samples were examined in relation to mechanical characteristics. The arc torch weaving at 1 Hz allowed us to interfere with the epitaxial growth of the β-Ti columnar grains and, thus, obtain them a lower aspect ratio. Upon cooling, the α/α′+β structure was formed inside the former β-Ti grains, and this structure proved to be more uniform as compared to that of the samples built without the weaving. The subtransus quenching of the samples in water did not have any effect on the structure and properties of samples built with the arc torch weaving, whereas a more uniform grain structure was formed in the sample built without weaving. Quenching resulted also in a reduction in the relative elongation by 30% in both cases.Keywords
Funding Information
- Government research assignment for ISPMS SB RAS (FWRW-2024-0001)
This publication has 54 references indexed in Scilit:
- Effects of weave path parameters on the geometry of wire arc additive manufactured featuresThe International Journal of Advanced Manufacturing Technology, 2022
- Oscillating wire arc additive manufacture of rocket motor bimetallic conical shellThe International Journal of Advanced Manufacturing Technology, 2022
- Directed Energy Deposition (DED) Process: State of the ArtInternational Journal of Precision Engineering and Manufacturing-Green Technology, 2021
- Defect Formation in Titanium Alloy during Non-stationary Process of Local MetallurgyRussian Physics Journal, 2020
- Optimization strategies for robotic additive and subtractive manufacturing of large and high thin-walled aluminum structuresThe International Journal of Advanced Manufacturing Technology, 2018
- Effect of interpass temperature on in-situ alloying and additive manufacturing of titanium aluminides using gas tungsten arc weldingAdditive Manufacturing, 2015
- Wire-feed additive manufacturing of metal components: technologies, developments and future interestsThe International Journal of Advanced Manufacturing Technology, 2015
- Morphology investigation on direct current pulsed gas tungsten arc welded additive layer manufactured Ti6Al4V alloyThe International Journal of Advanced Manufacturing Technology, 2011
- The Origin of Microstructural Diversity, Texture, and Mechanical Properties in Electron Beam Melted Ti-6Al-4VMetallurgical and Materials Transactions A, 2010
- Cost-affordable titanium: The component fabrication perspectiveJOM, 2007