CO2Laser Processing On Ceramic Substrates Of Light Emitting Diode Assisted By Compressed Gas
Authors:
- 3 July 2015
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 19 (3) , 400-415
Abstract
The use of ceramic substrates in high power LEDs is becoming increasingly common. However, the brittleness of ceramics makes them difficult to process and susceptible to cracking. This study used a CO2 laser with auxiliary gas to drill and cut Al2O3 and AlN ceramic substrates. The authors investigated the influences of parameters such as auxiliary gas pressure, laser power, repetition rate, and working speed on processing quality, in terms of pattern size, surface roughness, hole taper angle, and fracturing. The experiment results show that Al2O3 low-cost processing can be achieved with low laser power and high auxiliary gas pressure. In contrast, AlN has a high melting point and high thermal conductivity, for which lower auxiliary gas pressure is required to ensure high-quality processing.Keywords
This publication has 6 references indexed in Scilit:
- CO2 laser underwater machining of deep cavities in aluminaJournal of the European Ceramic Society, 2011
- Characterization of the drilling alumina ceramic using Nd:YAG pulsed laserJournal of Materials Processing Technology, 2009
- Overlapping rate effect on laser shock processing of 1045 steel by small spots with Nd:YAG pulsed laserSurface and Coatings Technology, 2008
- Light-Emitting Diodes2006
- Laser cutting of thick ceramic substrates by controlled fracture techniqueJournal of Materials Processing Technology, 2003
- Laser cutting of thick ceramic tileOptics & Laser Technology, 1997