Partial discharge. XVIII. Errors in the location of partial discharges in high voltage solid dielectric cables
Authors:
- 1 November 1993
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electrical Insulation Magazine
- Vol. 9 (6) , 15-22
Abstract
Errors in partial discharge (PD) location on high voltage dielectric cables caused by both mechanical and electrical phenomena are discussed. The sources of error relevant to PD location include errors in measuring time delays, scatter caused by noise and disturbances, pulse propagation distortion, errors in cable length measurement, and trivial errors in experimental technique. Experiments to determine typical PD location error were carried out using a detector with a 10 MHz bandwidth. Extensive tests were carried out on a 200 m, 15 kV cable with metering marks on the outer sheath, as well as a 590 m, 10 kV cable without metering marks.<>Keywords
This publication has 7 references indexed in Scilit:
- Partial discharge. VIII. PD testing of solid dielectric cableIEEE Electrical Insulation Magazine, 1991
- Partial discharge. III. Cavity-induced PD in solid dielectricsIEEE Electrical Insulation Magazine, 1990
- Partial discharge. II. Detection sensitivityIEEE Electrical Insulation Magazine, 1990
- Partial discharge: overview and signal generationIEEE Electrical Insulation Magazine, 1990
- Location and characterization of partial discharge sites in shielded power cablesIEEE Transactions on Power Delivery, 1990
- Location of Small Discharges in Plastics Insulated High Voltage CablesIEEE Transactions on Power Apparatus and Systems, 1985
- Fundamental Limitations in the Measurement of Corona and Partial DischargeIEEE Transactions on Electrical Insulation, 1982