Surface Potential and Magnetic Recording Media Tribology©
Authors:
- 1 January 1997
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 40 (1) , 69-74
Abstract
A Kelvin probe apparatus was developed to profile surface potential. Measurements were performed on unlubricated and lubricated carbon overcoated thin film magnetic recording media. The surface potential on perfluoropolyether-lubricated media was more negative than that on the unlubricated carbon overcoat. Sliding, start/slop, and low-flying tests were performed with two-rail sliders, and the surface potential was measured across the test tracks prior to detectable mechanical wear. The surface potential in the lest tracks became more negative with the number of cycles during sliding or start/stop and with decreasing slider-disk spacing during low flying. Degraded lubricants with polar carboxylic acid end groups accumulate and increase the dipole moment in the lest tracks.Keywords
This publication has 9 references indexed in Scilit:
- Surface diffusion of thin perfluoropolyalkylether filmsJournal of Applied Physics, 1996
- Tribochemistry at lubricated interfacesJournal of Vacuum Science & Technology A, 1994
- Mechanical scission of perfluoropolyethersJournal of Applied Polymer Science, 1993
- Contact potential measurement: Spacing-dependence errorsReview of Scientific Instruments, 1992
- The Decomposition Mechanism of Perfluoropolyether Lubricants during Wear1992
- Lubricant Removal, Degradation, and Recovery on Particulate Magnetic Recording MediaJournal of Tribology, 1992
- Molecular conformation and disjoining pressure of polymeric liquid filmsThe Journal of Chemical Physics, 1991
- Migration of liquid polymers on solid surfacesThe Journal of Chemical Physics, 1990
- Perfluoropolyethers: Their physical properties and behaviour at high and low temperaturesWear, 1971