Extrusion blow molding is utilized in the production of plastic hollow containers. One of the critical steps in the process sequence is the formation of an annular extrudate, called the parison. Extrusion of the parison through an annular die is associated with varying degrees of swell and sag along the length. Moreover, the design of many commercial blow molding products requires variations in wall thickness along the length of the parison. The present work describes the design and operation of an on-line computerized parison thickness profile measurement technique for the purpose of implementing closed loop control of the parison thickness profile. The proposed thickness measurement technique was evaluated by comparing it to the conventional pinch-off mold technique. The control strategy employed involves a simple on-line adaptive control scheme. Programmed set point profiles, such as constant, linear and oscillatory profiles were implemented to within a 5% error. Moreover, the adaptive controller compensates for system disturbances.