Microstructure and Composition Comparison of Ti‐ and Ta‐Doped Nb3Al Superconducting Wires Fabricated by RHQT Process
Authors:
- 29 May 2022
- journal article
- research article
- Published by Wiley in Physica Status Solidi (a)
- Vol. 219 (14)
Abstract
Herein, the microstructure and composition of the Ti‐ and Ta‐doped Nb3Al superconductor fabricated by rapid heating, quenching, and transformation (RHQT) process are compared. After rapid heating and quenching (RHQ) process, body‐centered cubic (bcc) phase is formed in all the wires, showing dark stripe and bright contrast morphology in the backscattered electron (BSE) images. After transformation heat‐treatment, all wires consist of A15 phase and show the same morphology as that of the quenched samples. Near‐stoichiometric composition is shown in 3 at% Ti‐ and Ta‐doped Nb3Al samples, but when doping amount is 10 at%, Ti‐doped sample has constant Nb content of 67 at% and Ta‐doped sample has Al + Ta content of 25 at%. Superconducting properties of both 3 at% Ti‐ and Ta‐doped Nb3Al samples are comparable and much superior than that of 10 at% doped samples, including critical temperature (Tc), critical current density (Jc), and irreversible field (Birr). Though 10 at% Ta‐doped Nb3Al has higher Tc than 10 at% Ti‐doped sample, it presents wider ΔTc value and lower Jc performance. When increasing the measurement temperature from 8 to 10 K, the decay ratio of Birr value for Ti‐doped Nb3Al superconductor follows the scaling law; however, the Ta‐doped samples are not the case.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (A0920502052201-408)
This publication has 26 references indexed in Scilit:
- Study of ${\rm Nb}_{3}{\rm Al}$ Wires for High-Field Accelerator Magnet ApplicationsIEEE Transactions on Applied Superconductivity, 2010
- Characterization of ${\rm Nb}_{3}{\rm Al}$ Strands Subjected to an Axial-Strain for a Fusion DEMO ReactorIEEE Transactions on Applied Superconductivity, 2009
- Influence of transformation heat treatment on microstructure and defects in RHQT-processed Nb/sub 3/AlIEEE Transactions on Applied Superconductivity, 2003
- Phase stability at high temperatures in the Nb-Al systemIEEE Transactions on Applied Superconductivity, 2003
- Influence of Nb/Al Composition on the Microstructure and Superconducting Properties of RHQT-processed Nb3Al Wire.Teion Kogaku (Journal of Cryogenics and Superconductivity Society of Japan), 2003
- Effect of rapid heating, quenching and transformation conditions on the superconducting properties and microstructure of Jelly-Roll processed Nb3Al superconductorsSuperconductor Science and Technology, 2002
- Large improvement in high-field critical current densities of Nb3Al conductors by the transformation-heat-based up-quenching methodSuperconductor Science and Technology, 2000
- Metallurgy and superconductivity in Nb-AlIEEE Transactions on Magnetics, 1981
- Metallurgy of bronze‐process A‐15 superconducting compositesCrystal Research and Technology, 1978
- Improved Jcin mechanically fabricated Nb3Al wires and ribbonsIEEE Transactions on Magnetics, 1975