Oil Removal from Produced Water by Ultrafiltration using Polysulfone Membrane
Open Access
- 1 April 2017
- journal article
- separation processes
- Published by FapUNIFESP (SciELO) in Brazilian Journal of Chemical Engineering
- Vol. 34 (2) , 583-596
Abstract
The present paper deals with the ultrafiltration (UF) of produced water using a polysulfone membrane. Membranes were prepared by the phase inversion technique using polysulfone (PSf) polymer base, poly vinyl pyrrolidone (PVP) additive and N-methyl-2-pyrrolidone (NMP) solvent. Prepared UF membranes were characterized by determining the surface morphology by scannaing electron microscopy (SEM), atomic force microscopy (AFM), porosity, (iii) water contact angle, equilibrium water content and pure water flux, whereas membrane performance was determined by measuring permeate flux and oil rejection using oily synthetic produced water. With the increase in trans-membrane pressure in the cell, the permeate flux increased significantly, but oil rejection showed a decreasing trend. The best UF membrane performance under different trans-membrane pressures was obtained by maintaining (90% oil rejection using an UF membrane with the following composition: PSf- 15%, PVP - 5% and NMP - 80%.Keywords
This publication has 21 references indexed in Scilit:
- Synthesis, characterization and performance studies of polysulfone/bentonite nanoparticles mixed-matrix ultra-filtration membranes using oil field produced waterSeparation and Purification Technology, 2015
- Enhanced DAF in breaking up oil-in-water emulsionsSeparation and Purification Technology, 2014
- Application of thin film composite membranes with forward osmosis technology for the separation of emulsified oil–waterJournal of Membrane Science, 2014
- Ultrafiltration of oil-in-water emulsion: Analysis of fouling mechanismMembrane Water Treatment, 2010
- Treatment of drinking water containing iron using ElectrocoagulationInternational Journal of Environmental Engineering, 2010
- Cellulose acetate and polyethersulfone blend ultrafiltration membranes. Part I: Preparation and characterizationsPolymers for Advanced Technologies, 2004
- Modeling of membrane fouling and flux decline in reverse osmosis during separation of oil in water emulsionsDesalination, 2003
- Separation of water and oil from water-in-oil emulsion by freeze/thaw methodSeparation and Purification Technology, 2003
- Break-up of oil-in-water emulsions induced by permeation through a microfiltration membraneJournal of Membrane Science, 1995
- Flux decline behaviour with low molecular weight solutes during ultrafiltration in an unstirred batch cellJournal of Membrane Science, 1992