Design and Development of a Novel Transtibial Cycling Prosthesis
Authors:
- 13 September 2019
- journal article
- research article
- Published by Wolters Kluwer Health in JPO Journal of Prosthetics and Orthotics
- Vol. 32 (2) , 134-141
Abstract
Introduction: This article describes the design methodology, creation, and testing of a bespoke transtibial prosthesis, manufactured in part using three-dimensional (3D) printing technology, to enable more effective transmission of dynamic pressure through pedals during cycling. Asymmetry in motion can occur during cycling between the affected and contralateral lower limb. This pilot study was devised to enable development of a prototype prosthesis using a flexible ankle joint design for people with transtibial lower-limb absence for use when participating in amateur sports cycling. Materials and Methods: Gait laboratory analysis and in-shoe plantar pressure measurement were used to simultaneously measure heel/ankle kinematics, plus pressure magnitude/distribution applied during cycling. A volunteer subject cycled on a static rig wearing either a standard unilateral transtibial prosthesis or a prototype prosthesis, which incorporated a simulated Achilles tendon. An able-bodied volunteer acted as a control. Results: The results indicate that cycling with the prototype prosthesis reduced bilateral ankle and heel kinematic misalignment by 64% and reduced unwanted pedal pressure during the cycling recovery phase from 60 N to 50 N. Conclusions: The use of 3D printing is a feasible option in the design and manufacture of lower-limb prostheses designed for cycling. Further research is needed to confirm this in a larger cohort of patients.Keywords
This publication has 17 references indexed in Scilit:
- Physical Activity/Exercise and Diabetes: A Position Statement of the American Diabetes AssociationDiabetes Care, 2016
- Motor adaptation to prosthetic cycling in people with trans-tibial amputationJournal of Biomechanics, 2014
- Symmetrical kinematics does not imply symmetrical kinetics in people with transtibial amputation using cycling modelJournal of Rehabilitation Research and Development, 2014
- Effect of alignment changes on sagittal and coronal socket reaction moment interactions in transtibial prosthesesJournal of Biomechanics, 2013
- Motivations and barriers to prosthesis users participation in physical activity, exercise and sportProsthetics and Orthotics International, 2012
- Sport prostheses and prosthetic adaptations for the upper and lower limb amputeesProsthetics and Orthotics International, 2012
- Pedaling Asymmetries in Cyclists With Unilateral Transtibial Amputation: Effect of Prosthetic Foot StiffnessJournal of Applied Biomechanics, 2011
- The Biomechanics of Cycling with a Transtibial AmputationProsthetics and Orthotics International, 2009
- The effect of prolonged cycling on pedal forcesJournal of Sports Sciences, 2003
- Lower extremity kinematic and kinetic adaptations in unilateral below-knee amputees during walkingGait & Posture, 1997