Abstract
The effect of topography in 3D printed polymer scaffolds on stem cell differentiation is a significantly under-explored area. Compared to 2D biomaterials on which various well-defined topographies have been incorporated and been shown to direct an arrange of cell behaviours including adhesion, cytoskeleton organisation and differentiation, incorporating topographical features to 3D polymer scaffolds is challenging due to the difficulty of accessing the inside of a porous scaffold. Only roughened strut surface has been introduced to 3D printed porous scaffolds. Here, a rapid, single-step 3D printing method to fabricate polymeric scaffolds consisting of micro-struts (ca. 60 µm) with micro-/nano-surface pores (0.2-2.4 µm) has been developed based on direct ink writing of an agitated viscous polymer solution. The density, size, and alignment of these pores can be controlled by changing the degree of agitation or the speed of printing. 3D printed scaffolds with micro-/nano-porous struts enhanced chondrogenic and osteogenic differentiation of MSCs without soluble differentiation factors. The topography also selectively affected adhesion, morphology and differentiation of MSC to chondrogenic and osteogenic lineages depending on the composition of the differentiation medium. This fabrication method can potentially be used for a wide range of polymers where desirable architecture and topography are required.
Funding Information
  • Development and Promotion of Science and Talent Projects (TH) (5302.3/4711)

This publication has 56 references indexed in Scilit: