Feasibility study of micro-groove cross hatched surface texturing on Ti6Al4V for improved biotribological performance in metal-on-polymer hip implant
Authors:
- 23 April 2019
- journal article
- research article
- Published by SAGE Publications in Tribology - Materials, Surfaces & Interfaces
- Vol. 13 (3) , 150-160
Abstract
This study investigates the feasibility of micro-groove cross hatched textures on Ti6Al4V articulating with Ultra High Molecular Weight Polyethylene (UHMWPE) for a Metal-on-Polymer (MoP) hip implant to improve biotribological performance. Keeping 10% texture area density with 10 µm groove depth, micro-grooves ranging from 50 µm to 250 µm in width are fabricated by Laser Surface Texturing (LST) technique over polished Ti6Al4V samples. Tribological performance of UHMWPE pins against Ti6Al4V plate is tested for the different loading conditions under biological environment using linear reciprocating tribometer. Worn out pin samples are examined for their surface interactions, wear mechanism, and morphology using Scanning Electron Microscope (SEM). The result shows that the selection of micro-groove texture width is critical for obtaining the maximum tribological benefits. Texture width equal or more than the Hertzian contact is reducing friction and wear up to 14% and 57%, respectively, at the tribo-pair and similarly decrease in pitch also enhances tribological performance.Keywords
This publication has 27 references indexed in Scilit:
- Effect of surface texturing on the elastohydrodynamic lubrication analysis of metal-on-metal hip implantsTribology International, 2010
- Effect of geometrical parameters in micro-grooved crosshatch pattern under lubricated sliding frictionTribology International, 2010
- Hip resurfacings revised for inflammatory pseudotumour have a poor outcomeThe Journal of Bone and Joint Surgery. British volume, 2009
- Ti based biomaterials, the ultimate choice for orthopaedic implants – A reviewProgress in Materials Science, 2009
- Friction and wear properties of UHMWPE against ion implanted titanium alloySurface and Coatings Technology, 2007
- Textured surfaces for improved lubrication at high pressure and low sliding speed of roller/piston in hydraulic motorsTribology International, 2007
- Effects of orthopaedic wear particles on osteoprogenitor cellsBiomaterials, 2006
- Effect of surface texturing on friction reduction between ceramic and steel materials under lubricated sliding contactWear, 2003
- Lubrication and wear of ultra-high molecular weight polyethylene in total joint replacementsTribology International, 1998
- A comparative evaluation of the wear of ultra-high molecular weight polyethylene abraded by Ti-6Al-4VWear, 1974