Carbon‐Supported Iron Sulfide Catalysts

Authors:

Abstract
Carbon‐supported iron sulfide catalysts were characterized by means of thiophene hydrodesulfurization and butene hydrogenation activity measurements in a flow micro reactor, operating at atmospheric pressure. The iron content was varied from 0.03–1.9 Fe atoms per nm2 support surface area (0.3–17.7 wt% Fe). Oxidic catalyst precursor systems were dried either at 293K, or at 293K and subsequently at 383K.Dispersion of the oxidic iron phase present in the dried catalyst precursors and in the reoxidized sulfided catalysts was determined by Mössbauer spectroscopy, while X‐ray photoelectron spectroscopy was used for characterization of oxidic and sulfided catalysts.Carbon‐supported iron sulfide catalysts had a much higher HDS activity than alumina‐supported ones. They were also more active and less sensitive to deactivation than carbon‐supported molybdenum sulfide catalysts, which were the better hydrogenation catalysts.Drying of oxidic iron catalyst precursors at 383K caused a significant sintering and a lower catalytic activity. Sintering was also observed to occur during catalyst presulfiding. The extent of sintering appeared to increase with surface loading. The oxidic iron phase of the freshly prepared catalyst precursors dried at 293K consisted mainly of small iron(III) oxide particles (<40 A), which were, at least at low surface loadings, inhomogeneously distributed over the support surface.Iron(II) sulfide was found to be the main active phase. It was also noticed that considerable amounts of elemental sulfur are formed during sulfiding.

This publication has 16 references indexed in Scilit: