Dislocation-Source Hardening in Nanostructured Steel Produced by Severe Plastic Deformation
Authors:
- 12 January 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 638-642, 1959-1964
Abstract
Annealing-induced hardening and deformation-induced softening behavior has recently been found in nanostructured aluminum (fcc) produced by severe plastic deformation. It has also been demonstrated that annealing led to a decrease in ductility while deformation led to an increase in ductility. These mechanical responses are totally opposite to those in conventional coarse-grained samples. The present study explores the effect of post-process annealing or deformation on mechanical properties of nanostructured interstitial free (IF) steel (bcc). Accumulative roll-bonding was used to produce the nanostructured IF steel. The deformation structure was characterized by a lamellar boundary structure with a mean spacing of about 200 nm, consisting of high-angle boundaries, low-angle dislocation boundaries and dislocations in the volume between the boundaries. When the deformed sample was annealed at 400oC for 0.5 h, the yield stress and ultimate tensile strength increased and the elongation to failure decreased markedly. In contrast, when the annealed treatment was followed by a light rolling deformation of 15 % thickness reduction, the strength decreased and the elongation to failure increased. These results are consistent with those observed in the aluminum samples. Structural observations by transmission electron microscopy indicated that a removal of dislocations between the boundaries leads to a lack of dislocation sources, resulting in a higher stress to activate alternative dislocation sources. It was suggested that deformation rather than annealing could be a new route to improve the ductility of nanostructured metals and that a moderate light deformation gives a good balance of strength and ductility.Keywords
This publication has 16 references indexed in Scilit:
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- Effect of strain path on texture and annealing microstructure development in bulk pure copper processed by simple shearActa Materialia, 2005
- Microstructural parameters and flow stress in Al–0.13% Mg deformed by ECAE processingMaterials Science and Engineering: A, 2004
- Effects of annealing and impurities on tensile properties of electrodeposited nanocrystalline NiScripta Materialia, 2004
- Optimization of strength and ductility in nanocrystalline and ultrafine grained metalsScripta Materialia, 2003
- The effect of annealing on tensile deformation behavior of nanostructured SPD titaniumScripta Materialia, 2003
- Strength and ductility of ultrafine grained aluminum and iron produced by ARB and annealingScripta Materialia, 2002
- Microstructures and hardness of ultrafine-grained Ni3AlActa Metallurgica et Materialia, 1993
- The Hall-Petch relation in submicro-grained Al-1.5% Mg alloyScripta Metallurgica et Materialia, 1992
- Grain-size dependent hardening and softening of nanocrystalline Cu and PdScripta Metallurgica et Materialia, 1992