Evaluating Al2O3 gas diffusion barriers grown directly on Ca films using atomic layer deposition techniques
- 8 November 2012
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 31 (1)
Abstract
Al2O3 gas diffusion barriers grown directly on Ca films using atomic layer deposition (ALD) techniques were evaluated using several methods based on Ca oxidation. The Al2O3 ALD films were grown on Ca films at 120 °C using trimethylaluminum and H2O as the reactants. The oxidation of the Ca films was then monitored versus time at 70 °C and ∼28% relative humidity either by measuring the electrical conductance of the Ca film or by recording the photographic image of the Ca film. In the photographic images, the Ca films revealed that the Al2O3 ALD films have a small number of pinhole defects that lead to Ca film oxidation areas that grow radially around the pinhole defect versus time. A burst of new oxidation areas also appeared suddenly at later times and grew radially versus time. This rapid “blooming” may be related to another type of defect caused by water corrosion of the Al2O3 ALD films. In the electrical conductance measurements, the conductance of the Ca film initially showed little change versus time. The conductance then dropped rapidly when the oxidation area in the photographic image was a noticeable fraction of the Ca film area. The conductance measurements yielded a water vapor transmission rate (WVTR) value of ∼2 × 10−2 g/(m2 day) prior to the rapid reduction of the conductance. The photographic images of the Ca film were also analyzed to obtain a WVTR value assuming radial oxidation of the Ca film around defects. The WVTR values obtained from the electrical conductance and the photographic images were in approximate agreement and increased versus Ca film oxidation until the rapid blooming of new circular oxidation areas. The WVTR values are larger than previous measurements and may indicate that Al2O3 ALD films grown directly on Ca are less stable and degraded by Ca film oxidation. This study reveals that a range of WVTR values can be obtained from different variations of the Ca test depending on the extent of Ca film oxidation.Keywords
This publication has 45 references indexed in Scilit:
- Electrical calcium test for moisture barrier evaluation for organic devicesReview of Scientific Instruments, 2011
- The impact of water vapor transmission rate on the lifetime of flexible polymer solar cellsApplied Physics Letters, 2008
- High sensitivity permeation measurement system for “ultrabarrier” thin filmsJournal of Vacuum Science & Technology A, 2007
- Gas diffusion barriers on polymers using Al2O3 atomic layer depositionApplied Physics Letters, 2006
- Method of Measuring Ultralow Water Vapor Permeation for OLED DisplaysProceedings of the IEEE, 2005
- High sensitivity gas permeability measurement system for thin plastic filmsReview of Scientific Instruments, 2004
- Thin-Film Permeation-Barrier Technology for Flexible Organic Light-Emitting DevicesIEEE Journal of Selected Topics in Quantum Electronics, 2004
- Permeation rate measurements by electrical analysis of calcium corrosionReview of Scientific Instruments, 2003
- Organic light-emitting devices with extended operating lifetimes on plastic substratesApplied Physics Letters, 2002
- Low moisture permeation measurement through polymer substrates for organic light emitting devicesThin Solid Films, 2002