Uniform cooling for concentrator photovoltaic cells and electronic chips by forced convective boiling in 3D-printed monolithic double-layer microchannel heat sink
Authors:
- Ali RadwanAli Radwan
- Shinichi OokawaraSOShinichi Ookawara
- Shinsuke MoriSMShinsuke Mori
- Mahmoud AhmedMAMahmoud Ahmed
- 1 June 2018
- journal article
- research article
- Published by Elsevier in Energy Conversion and Management
- Vol. 166, 356-371
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Higher Education of Egypt
This publication has 51 references indexed in Scilit:
- Analysis of heat transfer characteristics of double-layered microchannel heat sinkInternational Journal of Heat and Mass Transfer, 2012
- A numerical and experimental investigation of flow maldistribution in a micro-channel heat sinkInternational Communications in Heat and Mass Transfer, 2011
- CFD study of liquid-cooled heat sinks with microchannel flow field configurations for electronics, fuel cells, and concentrated solar cellsApplied Thermal Engineering, 2011
- Influence of the aspect ratio on boiling flows in rectangular mini-channelsExperimental Thermal and Fluid Science, 2011
- A novel high performance, ultra thin heat sink for electronicsInternational Journal of Heat and Fluid Flow, 2010
- Design of a jet impingement cooling device for densely packed PV cells under high concentrationSolar Energy, 2007
- Performance evaluation of hybrid PV/thermal water/air heating system: A parametric studyRenewable Energy, 2006
- Experiments and modeling of the hydraulic resistance and heat transfer of in-line square pin fin heat sinks with top by-pass flowInternational Journal of Heat and Mass Transfer, 2005
- Cooling of photovoltaic cells under concentrated illumination: a critical reviewSolar Energy Materials and Solar Cells, 2005
- Analysis of two-layered micro-channel heat sink concept in electronic coolingInternational Journal of Heat and Mass Transfer, 1999