Surface coating affecting charge distribution and flashover voltage of cone-type insulator under DC stress
Authors:
- 29 May 2019
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 26 (3) , 706-713
Abstract
In order to scale down the dimensions of gas insulated line (GIL) insulators and to improve their reliability at ultra high voltage (UHV), considerable research has been conducted to raise the flashover voltage of the insulators. Usually, a non-uniform electric field distribution is an important factor triggering flashovers. Under AC and impulse voltages, the application of functionally graded materials (FGM) with spatial distribution of dielectric permittivity (ε-FGM) has been shown to be an effective solution. But at DC, the electric field distribution depends not only on the conductivity of the dielectrics but also the charge distribution on the surface. Based on the cone-type insulator, this paper reports on the surface charge accumulation and DC flashover of epoxy (EP)/graphene (GR) coated insulators in air. The EP/GR coated insulators with different filler amounts were prepared to test their surface charge accumulation and flashover characteristics. The results show that the uniformly distributed homopolar surface charge is helpful in reducing the peak electric field thereby raising the flashover voltage. The 0.1% EP/GR composite has the slowest surface potential decay process. Accordingly, the 0.1% coated insulator has the highest flashover voltage among the other EP/GR coated insulators and uncoated insulator. The bipolar surface charge regions caused by wire-type metal particles distort the electric field distribution. Flashovers of the 0.1% coated insulator occurs at lower voltage than the uncoated insulator when a wire-type particle attaches to the surface.Keywords
This publication has 18 references indexed in Scilit:
- Plasma surface treatment to improve surface charge accumulation and dissipation of epoxy resin exposed to DC and nanosecond-pulse voltagesJournal of Physics D: Applied Physics, 2017
- Surface modification of epoxy using an atmospheric pressure dielectric barrier discharge to accelerate surface charge dissipationIEEE Transactions on Dielectrics and Electrical Insulation, 2017
- Nonlinear conductivity and interface charge behaviors between LDPE and EPDM/SiC composite for HVDC cable accessoryIEEE Transactions on Dielectrics and Electrical Insulation, 2017
- Space charge behaviors of PP/POE/ZnO nanocomposites for HVDC cablesIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Fabrication and simulation of permittivity graded materials for electric field grading of gas insulated power apparatusIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Lightning Protection of 500-kV DC Gas-Insulated Lines (GIL) With Integrated Surge ArrestersIEEE Transactions on Power Delivery, 2015
- Influence of surface charge on DC flashover characteristics of epoxy/BN nanocompositesIEEE Transactions on Dielectrics and Electrical Insulation, 2014
- The energy distribution of localized states in polystyrene, based on isothermal discharge measurementsJournal of Physics D: Applied Physics, 1990
- Carrier transport in high-density polyethyleneJournal of Physics D: Applied Physics, 1979
- Drift mobility determinations using surface-potential decay in insulatorsJournal of Applied Physics, 1976