Trajectory Control of Incompletely Restrained Parallel-Wire-Suspended Mechanism Based on Inverse Dynamics
Authors:
- N. YanaiNYN. Yanai
- A. MohriAMA. Mohri
- 4 October 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Robotics
- Vol. 20 (5) , 840-850
Abstract
This paper discusses parallel wire mechanisms where an end-effector of the mechanism is suspended by multiple wires. The mechanisms enable not only three-dimensional (3-D) positioning but also 3-D orienting of the end-effector, unlike typical wire suspension-type mechanisms such as overhead crane. To discuss the parallel-wire-suspended mechanisms generally, two forms of basic dynamic equations are presented. Then the parallel wire mechanisms are classified into two types based on the basic equations. Dynamical properties of the two types of wire-suspended positioning mechanism are discussed. In this paper, one of the wire-suspended mechanism, incompletely restrained-type parallel wire mechanism, is mainly discussed on its inverse dynamics problem and its trajectory control problem. The inverse dynamics problem for the incompletely restrained-type mechanism plays an important role on its control problem, because the mechanism has low stiffness based on incomplete constraints on the suspended object which is governed by its dynamics. The paper proposes an antisway control method for the suspended object. In the method, the inverse dynamics calculation is used for nonlinear dynamics compensation to control the suspended object of the incompletely restrained parallel wire mechanism.Keywords
This publication has 23 references indexed in Scilit:
- Modelling and control of two co-operating planar cranes2002
- Inverse dynamics analysis and trajectory generation of incompletely restrained wire-suspended mechanisms2002
- Inverse kinematics analysis for incompletely restrained parallel wire mechanisms2002
- The Manipulability of Wire Suspension System.Journal of the Robotics Society of Japan, 1994
- Development of a Seven Degrees of Freedom Crane with Three Wires (1st Report)Journal of the Japan Society for Precision Engineering, 1993
- Nonlinear Modeling and Control of Overhead Crane Load SwayJournal of Dynamic Systems, Measurement, and Control, 1988
- Time optimal control of overhead cranes with hoisting of the loadAutomatica, 1987
- Modeling and Control of a Rotary CraneJournal of Dynamic Systems, Measurement, and Control, 1985
- Optimal control of container cranesAutomatica, 1982
- Optimal control of a rotary craneJournal of Optimization Theory and Applications, 1981