Effect of Ceramic Veneering on the Microstructure of Pre-sintered Cobalt-Chromium, Compared to Pre-sintered Zirconia and Conventional Cast Alloys
Authors:
Open Access
- 27 August 2024
- journal article
- Published by Knowledge E DMCC in Frontiers in Dentistry
- Vol. 21, 32
Abstract
Objectives: We aimed to evaluate ceramic-alloy interface and emphasize the alteration of alloy microstructure after ceramic layering. Materials and Methods: Thirty-two discs made from a ceramic-alloy combination of pre-sintered cobalt-chromium (CoCr), cast CoCr, cast nickel-chromium (NiCr), or pre-sintered zirconia were prepared with eight discs in each group. Four specimens were examined as manufactured and four were ceramic-layered. Scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), X-Ray diffractometer (XRD), and an atomic force microscope were used for analysis. Non-layered specimens received ceramic fire-heating without adding any ceramic. Alloy microstructure was compared before and after ceramic veneering or heating within the same group. Mean differences in grain size and surface roughness were compared among groups. P<0.05 was considered significant. Results: SEM showed a close bonding interface between alloys and ceramics. EDX demonstrated differences compared to the manufacturer’s composition. Ceramic-layering reduced grain size for both milled alloys (P<0.05), whereas grain size increased in cast groups (P=0.011). Heat treatment did the same for the CoCr groups (P=0.013). Ceramic veneering increased the surface roughness of the cast CoCr (Gi) (P=0.029) and NiCr (Wi) (P=0.005) groups, whereas zirconia roughness average (Ra) showed a slight decrease (P=0.282). XRD showed no differences among zirconia, NiCr, and milled CoCr groups before and after veneering. Crystallite size differed between monoclinic and tetragonal phases in zirconia. Conclusion: The study highlights that ceramic-layering induces significant microstructural changes in alloys, enhancing bonding potential and mechanical stability. Pre-sintered materials show a fine homogeneous surface, optimizing ceramic adherence and potentially improving clinical outcomes.Keywords
This publication has 23 references indexed in Scilit:
- Confocal Raman microscopic analysis of the zirconia/feldspathic ceramic interfaceDental Materials, 2012
- Thermal gradients and residual stresses in veneered Y-TZP frameworksDental Materials, 2011
- XRD2 micro-diffraction analysis of the interface between Y-TZP and veneering porcelain: Role of application methodsDental Materials, 2010
- Ceramic pressed to metal versus feldspathic porcelain fused to metal: a comparative study of bond strength.2009
- Evaluation of interface characterization and adhesion of glass ceramics to commercially pure titanium and gold alloy after thermal- and mechanical-loadingDental Materials, 2009
- Shear bond strengths between different zirconia cores and veneering ceramics and their susceptibility to thermocyclingDental Materials, 2008
- Surface analysis of porcelain fused to metal systemsDental Materials, 2006
- The effect of oxidation heat treatment on porcelain bond strength in selected base metal alloysThe Journal of Prosthetic Dentistry, 1991
- The effect of recasting on the oxidation layer of a palladium-silver porcelain alloyThe Journal of Prosthetic Dentistry, 1988
- Bonding mechanism evidence in a ceramic–nonprecious alloy systemJournal of Biomedical Materials Research, 1977