Anchor Loss Variation in MEMS Wine-Glass Mode Disk Resonators Due to Fluctuating Fabrication Process
- 28 June 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 16 (18) , 6846-6856
Abstract
With increasing demand for high-frequency, high-quality factor (Q-factor) mechanical resonators, the Q-factor declining issue at high-frequency becomes increasingly prominent. This paper studies the performance variations of disk resonators under the wine-glass vibration mode due to the support beam offset that are caused by process deviations. The formula of the Q-factor in terms of the support loss is derived to further illustrate the change of the Q-factor caused by the beam offset. It is found that the impact of the extensional mode on the performance is more serious than that of the flexural mode, since the extensional mode may destruct the mode shape and decrease the radial size (i.e., amplitude) of the disk. Finally, some design methods on how to improve the Q-factor of the resonator are given. The numerical results show that there are, respectively, 0.07% and 13.7% increase in the resonant frequency and the disk radial size when the support beam offset is 4°, whereas the increase in the resonant frequency and the disk radial size becomes 0.96% and 69.8%, respectively, when the support beam offset reaches 16°. For the Q-factor, although the flexural-mode Q-factor, Q f , increases with increasing support beam offset, the overall Q-factor of the resonator still decreases due to the dominant extensional-mode loss. In the worst case, the largest decline reaches 27.11% from the zero offset position (where there is only flexural-mode loss) to the 16° offset position.Keywords
Funding Information
- National Natural Science Foundation of China (61376117, 61411136003)
- Zhejiang Provincial Natural Science Foundation of China (LY13F040004)
This publication has 26 references indexed in Scilit:
- Micromechanical ring resonators with a 2D phononic crystal support for mechanical robustness and providing mask misalignment tolerance2015
- The slope effect of a capacitive resonator profile fabricated by a DRIE process on the performance of an MEMS disk resonatorJournal of Micromechanics and Microengineering, 2014
- Particle Swarm Optimization for Design of Slotted MEMS Resonators With Low Thermoelastic DissipationJournal of Microelectromechanical Systems, 2013
- Attachment loss of micromechanical and nanomechanical resonators in the limits of thick and thin support structuresJournal of Applied Physics, 2007
- Elastic wave transmission at an abrupt junction in a thin plate with application to heat transport and vibrations in mesoscopic systemsPhysical Review B, 2001
- GENERAL EQUATIONS OF ANISOTROPIC PLATES AND SHELLS INCLUDING TRANSVERSE SHEAR DEFORMATIONS, ROTARY INERTIA AND INITIAL CURVATURE EFFECTSJournal of Sound and Vibration, 2000
- High-Q HF microelectromechanical filtersIEEE Journal of Solid-State Circuits, 2000
- Thermoelastic damping in micro- and nanomechanical systemsPhysical Review B, 2000
- Viscous damping model for laterally oscillating microstructuresJournal of Microelectromechanical Systems, 1994
- Slide film damping in laterally driven microstructuresSensors and Actuators A: Physical, 1994