The Influence of Cutting Parameters on the Cutting Forces when Milling Invar36
Authors:
- 1 July 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 988, 296-299
Abstract
An experimental study on milling of Invar36 was conducted by using coated carbide insert to characterize the cutting force. The Taugchi's design of experiment was used for experimentation and the cutting force regression equation was established based on the principles of probability statistics and regression analysis. The results showed that the cutting force was significantly affected by the axial depth of cut and the feed per tooth, and with the increase of the axial depth of cut, the cutting force increased very quickly. Compared with the axial depth of cut, radial depth of cut and cutting speed had less influence on the cutting force. The established regression equation was highly reliable.Keywords
This publication has 3 references indexed in Scilit:
- Fibre reinforced composites in aircraft constructionProgress in Aerospace Sciences, 2005
- Preliminary study on cost optimisation of aircraft composite structures applicable to liquid moulding technologiesComposite Structures, 2002
- A century of zero expansionNature, 1999