Insights on the Influence of the Central-Cut Width of the Box Assembly with Removable Component on Its Dynamical Responses
Open Access
- 6 February 2025
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 15 (3) , 1671
Abstract
This investigation focuses on the dynamical effects caused by varying the central-cut width within the Box Assembly with Removable Component (BARC) system. The central-cut widths included in this study are a 0.5″ cut, a 0.25″ cut, a thin 0.1″ cut, and a structure that did not have a cut at all. Finite element analysis was conducted to determine the mode shapes and natural frequencies of each of the BARC structures. Structural dynamics experiments were run to examine the effects of the central-cut width on the dynamical responses and nonlinear characteristics of the BARC system. Free vibration testing with an impact hammer was carried out to excite the system and extract the dominant frequencies and directions of the significant responses. A pseudorandom vibration test that allows for the qualitative determination of any nonlinear behavior within the system was performed. This type of behavior can include nonlinear softening, nonlinear hardening, and the most common, nonlinear damping due to the presence of several bolted-joint connections and the possible activation of geometric and inertia nonlinearities. To quantitatively investigate the impacts of the central-cut width on the dynamics of the system, swept sinusoidal testing was conducted. It is determined that almost all systems with central cuts demonstrate the presence of nonlinear softening, but at times, nonlinear hardening trends are seen, particularly in the 0.1″ cut and no-cut systems when testing harmonically. Each of the central-cut systems displays nonlinear damping, with the amount of damping generally increasing as the central cut decreases in size. The effect of the central cut of the BARC system on the mode-switching ability of the system is negligible; however, mode switching takes place when comparing the central-cut configurations to the no-cut one. These results show the significance of accurately measuring the central-cut width and how geometric uncertainty may change the dynamical responses and nonlinear properties of the system.Keywords
Funding Information
- Los Alamos National Laboratory
This publication has 20 references indexed in Scilit:
- Effects of test fixture connections and interference of the BARC structure on its dynamical responsesInternational Journal of Mechanical Sciences, 2022
- Comparison of Different Approaches to Include Connection Elements into Frequency-Based SubstructuringExperimental Techniques, 2020
- Introduction of line contact in frequency-based substructuring process using measured rotational degrees of freedomJournal of Physics: Conference Series, 2019
- Nonlinear modeling of structures with bolted joints: A comparison of two approaches based on a time-domain and frequency-domain solverMechanical Systems and Signal Processing, 2019
- Integration of system identification and finite element modelling of nonlinear vibrating structuresMechanical Systems and Signal Processing, 2018
- Full-degrees-of-freedom frequency based substructuringMechanical Systems and Signal Processing, 2018
- Nonlinear damping and quasi-linear modellingPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2015
- Model Order Reduction for Linear and Nonlinear Systems: A System-Theoretic PerspectiveArchives of Computational Methods in Engineering, 2014
- Encyclopedia of Vibration: Volumes 1, 2, and 3Applied Mechanics Reviews, 2002
- Model Updating In Structural Dynamics: A SurveyJournal of Sound and Vibration, 1993