Effect of Attenuation on Backward-Wave Oscillation Start Oscillation Condition
- 13 December 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 32 (6) , 2184-2188
Abstract
In a practical helix traveling-wave tube (TWT), there is always attenuator/sever for suppressing the oscillations, including backward-wave oscillation (BWO). The factors of the influencing BWO include start position of the attenuator, its length, and attenuation quantity. In the event that the attenuator/sever and nonuniformities in the phase velocity and beam potential were considered, a linear theory is employed to analyze BWO start oscillation condition. Numerical results show that the start oscillation length of the TWT decreases when the start position of the attenuator is close to the input section of the slow wave structure (SWS), that Start oscillation current of the output section of the SWS increases as the attenuation length decreasing, or the attenuation quantity increasing or the nonuniformities becoming strong, and that, however, when the phase velocity or beam potential exceeds a particular value, no oscillation condition could be found.Keywords
This publication has 11 references indexed in Scilit:
- Stability of traveling-wave amplifiers with reflectionsIEEE Transactions on Plasma Science, 2002
- Two-dimensional small signal analysis of backward-wave oscillation in a helix traveling-wave tube under Brillouin-flow, periodic permanent magnetic focusingIEEE Transactions on Electron Devices, 2001
- Backward-wave suppression in a very wide-band helix travelling-wave tube using a slow waveguide filterIEE Proceedings H Microwaves, Antennas and Propagation, 1991
- Numerical analysis and design for high-performance helix traveling-wave tubesIEEE Transactions on Electron Devices, 1985
- A two wave theory of traveling-wave tubes and backward-wave oscillationsIEEE Transactions on Electron Devices, 1975
- Starting conditions for backward-wave oscillators with large loss and large space chargeIEEE Transactions on Electron Devices, 1970
- Start-oscillation conditions in nonuniform backward-wave oscillatorsIEEE Transactions on Electron Devices, 1964
- Start-oscillation conditions of tapered backward-wave oscillatorsIEEE Transactions on Electron Devices, 1963
- Suppression of backward–wave oscillation by filter helix methodsIRE Transactions on Electron Devices, 1955
- Analysis of the Backward-Wave Traveling-Wave TubeProceedings of the IRE, 1954