Effect of sub-micron grains and defect-dipole interactions on dielectric properties of iron, cobalt, and copper doped barium titanate ceramics
Authors:
Open Access
- 14 September 2023
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Chemistry
- Vol. 11, 1249968
Abstract
Introduction: Dilutely doped ferroelectric materials are of interest, as engineering these materials by introducing point defects via doping often leads to unique behavior not otherwise achievable in the undoped material. For example, B-site doping with transition metals in barium titanate (BaTiO3, or BTO) creates defect dipoles via oxygen vacancies leading enhanced polarization, strain, and the ability to tune dielectric properties. Though defect dipoles should lead to dielectric property enhancements, the effect of grain size in polycrystalline ferroelectrics such as BTO plays a significant role in those properties as well.Methods: Herein, doped BTO with 1.0% copper (Cu), iron (Fe), or cobalt (Co) was synthesized using traditional solid-state processing to observe the contribution of both defect-dipole formation and grain size on the ferroelectric and dielectric properties.Results and discussion: 1.0% Cu doped BTO showed the highest polarization and strain (9.3 μC/cm2 and 0.1%, respectively) of the three doped BTO samples. While some results, such as the aforementioned electrical properties of the 1.0% Cu doped BTO can be explained by the strong chemical driving force of the Cu atoms to form defect dipoles with oxygen vacancies and copper’s consistent +2 valency leading to stable defect-dipole formation (versus the readily mixed valency states of Fe and Co at +2/+3), other properties cannot. For instance, all three Tc values should fall below that of undoped BTO (typically 120°C–135°C), but the Tc of 1.0% Cu BTO actually exceeds that range (139.4°C). Data presented on the average grain size and distribution of grain sizes provides insight allowing us to decouple the effect of defect dipoles and the effect of grain size on properties such as Tc, where the 1.0% Cu BTO was shown to possess the largest overall grains, leading to its increase in Tc.Conclusion/future work: Overall, the 1% Cu BTO possessed the highest polarization, strain, and Tc and is a promising dopant for engineering the performance of the material. This work emphasizes the challenge of extricating one effect (such as defect-dipole formation) from another (grain size modification) inherent to doping polycrystalline BTO.Keywords
This publication has 34 references indexed in Scilit:
- Domain Size Effect on Dielectric Properties of Barium Titanate CeramicsJapanese Journal of Applied Physics, 2008
- Characterization of Defect Structure in Acceptor‐Modified Piezoelectric Ceramics by Multifrequency and Multipulse Electron Paramagnetic Resonance SpectroscopyJournal of the American Ceramic Society, 2008
- Association of oxygen vacancies with impurity metal ions in lead titanatePhysical Review B, 2007
- Oxygen Vacancy Relaxation and Domain Wall Hysteresis Motion in Cobalt‐Doped Barium Titanate CeramicsJournal of the American Ceramic Society, 2005
- Grain-size effects on the ferroelectric behavior of dense nanocrystallineceramicsPhysical Review B, 2004
- Large electric-field-induced strain in ferroelectric crystals by point-defect-mediated reversible domain switchingNature Materials, 2004
- Effect of Fe Doping of Thin (Ba,Sr)TiO3Films on Increase in Dielectric ConstantJapanese Journal of Applied Physics, 2002
- Atomistic Simulation of Dopant Incorporation in Barium TitanateJournal of the American Ceramic Society, 2001
- Electrical after-effects in Pb(Ti, Zr)O3 ceramicsFerroelectrics, 1977
- Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenidesActa Crystallographica Section A, 1976