Wire arc additive manufacturing of thin and thick walls made of duplex stainless steel
Top Cited Papers
Open Access
- 13 May 2023
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 127 (1-2) , 381-400
Abstract
Wire arc additive manufacturing (WAAM) direct energy deposition is used to process two different duplex stainless steels (DSS) wire chemistries. Macro- and micromechanical response variables relevant to industrialization are studied using a design of the experiment (DoE) approach. The tested operation window shows that the variation of layer height and over-thickness are highly correlated with travel speed and wire feed speed and positively correlated with heat input. The maximum achieved average instantaneous deposition rate is 3.54 kg/h. The use of wire G2205, which contains 5 wt% nickel content, results in a ferrite-to-austenite ratio that is equally balanced, while wire G2209, with 9 wt% nickel, provides a lower ferrite content. The spatial distribution of Fe% is influenced by part geometry and path planning, and higher heat inputs result in coarser microstructures. The manufacturing weaving strategy generates a heterogeneous microstructure characterized by fluctuations in Fe%. Thus, understanding the effect of complex thermal history, higher-dimensional design spaces, and uncertainty quantification is required to drive metal WAAM toward full industrialization.Keywords
Funding Information
- Tampere University including Tampere University Hospital, Tampere University of Applied Sciences
This publication has 57 references indexed in Scilit:
- Influence of Oxygen Content on the Inclusion Formation and Pitting Corrosion Resistance of Hyper Duplex Stainless SteelsMATERIALS TRANSACTIONS, 2014
- The controlled short circuit GMAW process: A tutorialJournal of Manufacturing Processes, 2014
- Duplex Steels. Part II: Carbides and NitridesMetallography, Microstructure, and Analysis, 2013
- Effect of Different Chromium Additions on the Microstructure and Mechanical Properties of Multipass Weld Joint of Duplex Stainless SteelMetallurgical and Materials Transactions A, 2012
- The effect of large heat input on the microstructure and corrosion behaviour of simulated heat affected zone in 2205 duplex stainless steelCorrosion Science, 2011
- Characterisation of the cold metal transfer (CMT) process and its application for low dilution claddingJournal of Materials Processing Technology, 2011
- Characterization of microstructure, mechanical properties and corrosion resistance of dissimilar welded joint between 2205 duplex stainless steel and 16MnRMaterials & Design (1980-2015), 2011
- Optimization of electrophoretic deposition of alumina onto steel substrates from its suspension in iso-propanol using statistical design of experimentsMaterials Research Bulletin, 2008
- Effect of intermetallic precipitations on the properties of duplex stainless steelMaterials Characterization, 2007
- Influence of nitrogen in the shielding gas on corrosion resistance of duplex stainless steel weldsJournal of Materials Engineering and Performance, 1999