How does canal taper affect root stresses?
Authors:
- 28 February 2006
- journal article
- Published by Wiley in International Endodontic Journal
- Vol. 39 (3) , 226-237
Abstract
Aim To examine the effect of specific tapers on root stresses and thus vertical root fracture.Methodology The effect of taper on root stresses was calculated during simulated warm vertical compaction of gutta‐percha in a straight rooted premolar for three tapers (0.04, 0.06 and 0.12 mm mm−1) using finite element analysis. Stresses in the dentine were observed whilst the root was filled with three subsequent gutta‐percha increments. Each increment was compacted at 10 or 15 N and the gutta‐percha cooled down to 37 °C. After filling, composite was polymerized in the access space. A functional occlusal load of 50 N was then applied on the buccal cusp incline. The stress distribution in the root during the occlusal loading was compared with the stresses during filling.Results During filling, the highest stresses were found: (a) at the canal surface; (b) using the smallest taper; (c) in the apical third; and (d) during the first gutta‐percha increment. The root stress distribution changed when the functional post‐filling load was applied. It generated the highest stresses at the external root surface, with a tensile stress concentration at the lingual surface of the cervical third. Since the stresses during simulated masticatory loading concentrated on the external surface, an increased taper size caused only slightly higher root stress levels.Conclusions With increasing taper, root stresses decreased during root filling but tended to increase for masticatory loading. Root fracture originating at the apical third is likely initiated during filling, whilst fracture originating in the cervical portion is likely caused by occlusal loads.Keywords
This publication has 33 references indexed in Scilit:
- Mapping of tooth deformation caused by moisture change using moiré interferometryDental Materials, 2003
- Why do Shear Bond Tests Pull Out Dentin?Journal of Dental Research, 1997
- Resistance to vertical fracture of roots, previously fractured and bonded with glass ionomer cement, composite resin and cyanoacrylate cementDental Traumatology, 1993
- A classification of dental composites according to their morphological and mechanical characteristicsDental Materials, 1992
- Finite element analysis of three‐ and four‐unit bridgesJournal of Oral Rehabilitation, 1989
- Clinical survey of fractured teethThe Journal of the American Dental Association, 1987
- Diagnosis and possible causes of vertical root fracturesOral Surgery, Oral Medicine, Oral Pathology, 1980
- Composition and Mechanical Properties of Gutta-Percha Endodontic PointsJournal of Dental Research, 1975
- Pattern Waxes and Their Manipulation in Cast Gold Inlay Technic**Read before the Section on Partial Dentures at the Midwinter Clinic of the Chicago Dental Society, Feb. 2, 1931.The Journal of the American Dental Association (1922), 1931
- Report of Laboratory Investigations on the Physical Properties of Root Filling Materials and the Efficiency of Root Fillings for Blocking Infection from Sterile Tooth StructuresThe Journal of the National Dental Association, 1918