Anisotropy in Additively Manufactured Concrete Specimens under Compressive Loading—Quantification of the Effects of Layer Height and Fiber Reinforcement
Open Access
Abstract
This paper analyzes the effect of print layer heights and loading direction on the compressive response of plain and fiber-reinforced (steel or basalt fiber) 3D printed concrete. Slabs with three different layer heights (6, 13, and 20 mm) are printed, and extracted cubes are subjected to compression (i) along the direction of printing, (ii) along the direction of layer build-up, and (iii) perpendicular to the above two directions. Digital image correlation (DIC) is used as a non-contact means to acquire the strain profiles. While the 3D printed specimens show lower strengths, as compared to cast specimens, when tested in all three directions, this effect can be reduced through the use of fiber reinforcement. Peak stress and peak strain-based anisotropy coefficients, which are linearly related, are used to characterize and quantify the directional dependence of peak stress and strain. Interface-parallel cracking is found to be the major failure mechanism, and anisotropy coefficients increase with an increase in layer height, which is attributable to the increasing significance of interfacial defects. Thus, orienting the weaker interfaces appropriately, through changes in printing direction, or strengthening them through material modifications (such as fiber reinforcement) or process changes (lower layer height, enables attainment of near-isotropy in 3D printed concrete elements.Keywords
Funding Information
- U.S. National Science Foundation (CMMI: 1727445, OISE: 2020095)
This publication has 70 references indexed in Scilit:
- Method of formulating geopolymer for 3D printing for construction applicationsMaterials & Design, 2016
- Additive manufacturing and sustainability: an exploratory study of the advantages and challengesJournal of Cleaner Production, 2016
- Large-scale 3D printing of ultra-high performance concrete – a new processing route for architects and buildersMaterials & Design, 2016
- Mechanical properties of structures 3D printed with cementitious powdersConstruction and Building Materials, 2015
- Crack propagation and strain localization in metallic particulate-reinforced cementitious mortarsMaterials & Design (1980-2015), 2015
- Complex concrete structuresComputer-Aided Design, 2015
- Structural built-up of cement-based materials used for 3D-printing extrusion techniquesMaterials and Structures, 2015
- Building components for an outpost on the Lunar soil by means of a novel 3D printing technologyActa Astronautica, 2014
- Hardened properties of high-performance printing concreteCement and Concrete Research, 2012
- Freeform Construction: Mega-scale Rapid Manufacturing for constructionAutomation in Construction, 2007