Anisotropic strength and plastic deformation behavior of MAX phase Ti3AlC2 under ultrahigh pressure
Open Access
- 3 February 2026
- journal article
- Published by OAE Publishing Inc. in Microstructures
- Vol. 6 (1)
Abstract
Machinable layered ternary carbides and nitrides (MAX phases) are a class of multifunctional materials combining the advantages of both ceramics and metals, making them of vital technological importance. Understanding their mechanical behavior is critical for practical applications and failure analysis. However, there is still no in situ investigation on their strength and plastic deformation under high pressure/stress. In this study, we investigate the strength and texture development of Ti3AlC2 under nonhydrostatic pressure up to 41 GPa. Clear strength anisotropy was observed and the lattice stress states of different planes were determined. At 41 GPa, the highest differential stresses supported by the (10-10) plane and (0008) plane are approximately 13.7 GPa and 4.5 GPa, respectively. The average strength exceeds that of stishovite, one of the strongest oxides. A strong 0001 deformation texture developed under ultra-high stress. This work clearly reveals the lattice-stress states and deformation behavior of Ti3AlC2 under high stress, offering direct experimental insights for the design and processing of MAX phase materials.Keywords
This publication has 59 references indexed in Scilit:
- Bending the rules: Strain accommodation in layered crystalline solids through nanoscale buckling over dislocationsJournal of the Mechanics and Physics of Solids, 2023
- High temperature micromechanical behavior of Ti2AlN particle reinforced TiAl based composites investigated by in-situ high-energy X-ray diffractionMaterials & Design, 2021
- Anisotropic plastic deformation of single crystals of the MAX phase compound Ti3SiC2 investigated by micropillar compressionActa Materialia, 2018
- First-principle investigation of pressure and temperature influence on structural, mechanical and thermodynamic properties of Ti3AC2 (A = Al and Si)Computational Materials Science, 2018
- On the relevance of kinking to reversible hysteresis in MAX phasesActa Materialia, 2014
- Significance of mechanical twinning in hexagonal metals at high pressureActa Materialia, 2012
- General trends in the structural, electronic and elastic properties of the M3AlC2 phases (M = transition metal): A first-principle studyComputational Materials Science, 2010
- Thermal shock behavior of Ti3AlC2 from between 200°C and 1300°CJournal of the European Ceramic Society, 2005
- Effects of temperature, strain rate and grain size on the compressive properties of Ti3SiC2Acta Materialia, 2005
- On the Reproduction of the Orientation Distribution Function of Texturized Samples from Reduced Pole Figures Using the Conception of a Conditional Ghost CorrectionPhysica Status Solidi (b), 1982