Tensile deformation behavior of TRIP-aided bainitic ferrite steel in the post-necking strain region
Open Access
- 1 January 2021
- journal article
- research article
- Published by Taylor & Francis in Science and Technology of Advanced Materials: Methods
- Vol. 1 (1) , 56-74
Abstract
Transformation induced plasticity (TRIP) steels present a remarkable balance of strength and ductility. However, their post-necking hardening behavior, which is required for press-forming and automobile crash simulation, is unreliable because of their stress-triaxiality dependency. Therefore, we analyzed the stress-triaxiality hardening in the post-necking strain regions of tensile loaded TRIP steel to accurately evaluate the stress and strain distribution. Tensile tests were accordingly conducted on small, round-bar specimens to evaluate the true stress vs. cross-sectional reduction ratio curves up to fracture. Additionally, the stress distribution inside each specimen was measured using synchrotron X-ray diffraction. Using these measurements, the hardening law for the TRIP steel was identified through a series of finite element (FE) simulations, in which a simplified phenomenological strain and stress-triaxiality hardening were found to agree well with the measurements in the post-necking strain region. As a result, the hardening rate of the TRIP steel showed a sudden decrease at the uniform elongation limit strain. The FE simulations including stress-triaxiality hardening successfully reproduced this hardening behavior up to the fracture, and the FE simulation including stress-triaxiality hardening and its saturation presented values closest to the XRD measurements. This simulation also agreed well with the measurements obtained in the tensile direction away from the neck center. A microstructural analysis of the retained austenite at the neck supported this result. The FE simulations revealed that a combination of the TRIP effect and its deactivation accelerates the localized deformation at the specimen neck under tensile loading. GRAPHICAL ABSTRACTKeywords
Funding Information
- GIMRT Program of the Institute for Materials Research, Tohoku University (18K0024, 19K0037, 20K0008)
- Japan Society for the Promotion of Science (KAKENHI, JP 20H02484)
- Japan Synchrotron Radiation Research Institute (2018B1318)
This publication has 39 references indexed in Scilit:
- Identification of the post-necking hardening behaviour of sheet metal by comparison of the internal and external work in the necking zoneJournal of Materials Processing Technology, 2011
- Semi phenomenological modelling of the behavior of TRIP steelsInternational Journal of Plasticity, 2011
- Microstructure-based constitutive modeling of TRIP steel: Prediction of ductility and failure modes under different loading conditionsActa Materialia, 2009
- Measurement of Internal Strain in Materials Using High Energy White X-Ray at SPring-8Materials Science Forum, 2008
- Damage concept for evaluating ductile cracking of steel structure subjected to large-scale cyclic strainingScience and Technology of Advanced Materials, 2004
- Ductility of 0.1-0.6C-1.5Si-1.5Mn Ultra High-strength TRIP-aided Sheet Steels with Bainitic Ferrite MatrixISIJ International, 2004
- Computational prediction of deformation behavior of TRIP steels under cyclic loadingInternational Journal of Mechanical Sciences, 2001
- A Continuous Damage Mechanics Model for Ductile FractureJournal of Engineering Materials and Technology, 1985
- Berechnung der elastischen Konstanten des Vielkristalls aus den Konstanten des EinkristallsThe European Physical Journal A, 1958
- Plastic instability under plane stressJournal of the Mechanics and Physics of Solids, 1952