Microstructure and Properties of Electrodeposited nc-TiO2/Ni–Fe and Ni–Fe Coatings
Open Access
- 22 September 2019
- journal article
- research article
- Published by Springer Nature in Metals and Materials International
- Vol. 26 (6) , 812-826
Abstract
In this study, nc-TiO2/Ni–Fe composite coatings, and Ni–Fe alloys as equivalents to their matrices, were obtained from citrate-sulphate baths in the electrodeposition process using direct current and pulse current conditions. The aim of the study was to examine the effects of TiO2nanoparticles and current conditions on the chemical composition, surface morphology, microstructure, microhardness and magnetic properties of the electrodeposited coatings. The results show that the concentration of Fe in Ni–Fe alloys is related to the current conditions and is higher in the case of pulse current electrodeposition, while such a relationship was not observed for composites. The reinforcement of composites with TiO2nanoparticles results in a more developed surface topography with many nodule-like structures. Composites and equivalent alloys deposited in pulse current are characterized by a finer grain size than those obtained in direct current. TiO2nanoparticles and their agglomerates, several tens of nanometres in size, are distributed randomly in the Ni–Fe matrix of composites deposited in both current conditions used. Incorporation of a high volume fraction of nc-TiO2, exceeding over a dozen percent, and decreasing the nanograin size in nc-TiO2/Ni–Fe composites electrodeposited under pulse current conditions, allow a higher hardness to be achieved than in their counterparts obtained using direct current. Magnetic measurements showed ferromagnetic ordering of pristine TiO2nanoparticles, however, the introduction of TiO2nanoparticles into the Ni–Fe matrix resulted in a decrease in coercivity and saturation magnetization.GraphicKeywords
Funding Information
- Akademia Górniczo-Hutnicza im. Stanislawa Staszica (15.11.110.509)
This publication has 38 references indexed in Scilit:
- Magnetic property and corrosion resistance of electrodeposited nanocrystalline iron–nickel alloysApplied Surface Science, 2012
- Magnetic properties of ZnO nanopowdersJournal of Alloys and Compounds, 2009
- Ni1−xFex (0.1<x<0.75) alloy foils prepared from a fluorborate bath using electrochemical depositionJournal of Alloys and Compounds, 2009
- Effect of chemical composition on corrosion and wear behaviour of the composite Ni–Fe–Al2O3 coatingsJournal of Materials Processing Technology, 2004
- Deformation of electrodeposited nanocrystalline nickelActa Materialia, 2003
- On the Influence of Twinning Processes on Columnar Crystallite Growth in Electrodeposited FilmsCrystal Research and Technology, 1993
- Nickel plating by pulse electrolysis: textural and microstructural modifications due to adsorption/desorption phenomenaJournal of Applied Electrochemistry, 1990
- Grain size dependence of coercivity and permeability in nanocrystalline ferromagnetsIEEE Transactions on Magnetics, 1990
- A Mathematical Model for the Electrodeposition of Alloys on a Rotating Disk ElectrodeJournal of the Electrochemical Society, 1988
- The Anomalous Codeposition of Iron-Nickel AlloysJournal of the Electrochemical Society, 1965