Abrasive Wear Resistance of Ultrafine Ausferritic Ductile Iron Intended for the Manufacture of Gears for Mining Machinery
Open Access
Abstract
The purpose of this study was to experimentally determine the abrasion wear properties of ausferritic ductile iron austempered at 250 °C in order to obtain cast iron of class EN-GJS-1400-1. It has been found that such a cast iron grade makes it possible to create structures for material conveyors used for short-distance transport purposes, required to perform in terms of abrasion resistance under extreme conditions. The wear tests addressed in the paper were conducted at a ring-on-ring type of test rig. The test samples were examined under the conditions of slide mating, where the main destructive process was surface microcutting via loose corundum grains. The mass loss of the examined samples was measured as a parameter characteristic of the wear. The volume loss values thus obtained were plotted as a function of initial hardness. Based on these results, it has been found that prolonged heat treatment (of more than 6 h) causes only an insignificant increase in the resistance to abrasive wear.Keywords
Funding Information
- Narodowe Centrum Badań i Rozwoju (PBS3/B5/45/2015)
This publication has 42 references indexed in Scilit:
- Influence of shot peening on the fatigue life of Cu–Ni austempered ductile ironMaterials Science and Engineering: A, 2012
- A new method for the estimation of the instantaneous speed relative fluctuation in a vibration signal based on the short time scale transformMechanical Systems and Signal Processing, 2009
- Effects of heat treatment on the erosion behavior of austempered ductile ironsWear, 2006
- Effect of microstructure on abrasion wear behavior of austempered ductile cast iron (ADI) processed by a novel two-step austempering processMaterials Science and Engineering: A, 2005
- TEM of nanostructured metals and alloysMaterials Science and Engineering: A, 2004
- Very strong bainiteCurrent Opinion in Solid State and Materials Science, 2004
- Bulk nanostructured materials from severe plastic deformationProgress in Materials Science, 2000
- Effects of successive austempering on the tribological behavior of ductile cast ironWear, 1999
- The particle size effect in abrasion studied by controlled abrasive surfacesWear, 1999
- Tensile strength and creep properties of nanocrystalline palladiumScripta Metallurgica et Materialia, 1990