Challenges in the formability of the next generation of automotive steel sheets
- 17 January 2018
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 34 (9) , 1112-1117
Abstract
Improving strength may lightweight car bodies by thinning the structure gauge while bearing the same crash loads. Development of the third generation advanced high-strength steels aiming to boost material ductility to over 30% total elongation has become the common sense of potential solutions for stamping. Not only total elongation but also several other parameters, involving presswork hardening, anisotropy ratio, strain rate sensitivity, uniform elongation, edge sensitivity and internal stress between phases, are critical in determining the formability under the complex stress and strain distributions during stamping. We clarify here the logic of formability and difficulties in this context of three types of steel: quenching and partitioning, δ-transformation-induced plasticity and medium Mn-TRIP.Keywords
Funding Information
- National Natural Science Foundation of China (U1560204, 51722402)
This publication has 53 references indexed in Scilit:
- Hot forming of boron steels using heated and cooled tooling for tailored propertiesJournal of Materials Processing Technology, 2012
- Characterization of mechanically sheared edges of dual phase steelsJournal of Materials Processing Technology, 2012
- Experimental and numerical analysis on formation of stable austenite during the intercritical annealing of 5Mn steelActa Materialia, 2011
- Experimental and theoretical study of thermal aspects of the hot stamping processApplied Thermal Engineering, 2011
- Mn partitioning during the intercritical annealing of ultrafine-grained 6% Mn transformation-induced plasticity steelScripta Materialia, 2011
- A review on hot stampingJournal of Materials Processing Technology, 2010
- Carbon partitioning to austenite from martensite or bainite during the quench and partition (Q&P) process: A critical assessmentActa Materialia, 2008
- Low-Carbon Manganese TRIP SteelsMaterials Science Forum, 2007
- Partitioning of carbon from supersaturated plates of ferrite, with application to steel processing and fundamentals of the bainite transformationCurrent Opinion in Solid State and Materials Science, 2004
- Carbon partitioning into austenite after martensite transformationActa Materialia, 2003