Overcoming BEOL Thermal Constraints in Heterogeneous Integration of $α$-Ga$_{2}$O$_{3}$ UV-C Photodetectors Using Low-Temperature Thermal Compression Bonding
- 19 May 2026
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 16 (6) , 1415-1422
Abstract
This work demonstrates a low-temperature heterogeneous integration strategy for α-Ga₂O₃-based functional devices that complies with the stringent thermal budget constraints (450 °C) has hindered direct monolithic integration with CMOS circuitry. To address this incompatibility, α-Ga₂O₃ was synthesized at 470 °C and subsequently integrated at 350 °C using a Cu–Cu thermal compression bonding (TCB) platform. A dual-functional Ti interlayer architecture, consisting of a 10 nm passivation layer and a 50 nm adhesion layer, facilitates low-temperature bonding while maintaining interfacial stability between metal and oxide layers. Cu–Cu TCB performed at 350 °C under an applied pressure of 10 MPa resulted in a continuous and void-free metallurgical junction. Atomic-scale interfacial analyses indicate that the 50 nm Ti adhesion layer plays a key role in limiting Cu diffusion and mitigating thermo-mechanical stress, contributing to the preservation of the α-Ga₂O₃ active layer during bonding. The heterogeneously integrated UV-C photodetector exhibits photo-to-dark current ratios comparable to those of devices fabricated under high-temperature growth conditions, even under ultra-low-intensity UV-C illumination. These results demonstrate that low-temperature Cu–Cu TCB can be extended beyond conventional BEOL-compatible packaging to enable the integration of high-temperature functional oxides within BEOL thermal constraints. This work highlights a packaging-level heterogeneous integration strategy rather than device-level performance optimization.Keywords
Funding Information
- National Research Foundation of Korea (RS-2023-00239657)
- National Research Foundation of Korea (RS-2024-00440244)
This publication has 35 references indexed in Scilit:
- Regulation of domain wall motion in PZT-based ceramics through the introduction of local stress fieldsCeramics International, 2024
- Investigation of bonding mechanism for low-temperature Cu Cu bonding with passivation layerApplied Surface Science, 2022
- A kinetic model of copper-to-copper direct bonding under thermal compressionJournal of Materials Research and Technology, 2021
- Using Cu Kα1/Kα2 Splitting and a Powder XRD System To Discuss X-ray GenerationJournal of Chemical Education, 2018
- Methodology for thermal budget reduction of SPER down to 450 °C for 3D sequential integrationNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2016
- Epitaxial growth and solar-blind photoelectric properties of corundum-structured α -Ga 2 O 3 thin filmsMaterials Letters, 2016
- How to Tune the Alumina Aerogels Structure by the Variation of a Supercritical Solvent. Evolution of the Structure During Heat TreatmentThe Journal of Physical Chemistry C, 2016
- Ionic conduction of Ti0.95Mg0.05P2O7 at intermediate temperaturesCeramics International, 2015
- Reversible orientation-biased grain growth in thin metal films induced by a focused ion beamScripta Materialia, 2005
- Selective wafer-level adhesive bonding with benzocyclobutene for fabrication of cavitiesSensors and Actuators A: Physical, 2003