Improvement of energy recovery potential of wet-refuse-derived fuel through bio-drying process
Authors:
- 16 November 2022
- journal article
- research article
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 25 (2) , 637-649
Abstract
This paper proposes novel wet-refuse-derived fuel (Wet-RDF) bio-drying process with the variation of initial organic substrate and moisture content. The bio-drying was carried out using 0.3 m3 lysimeter aerated continuously at different rates. Two conditions of Wet-RDF feedstock tested included: Experiment A ‒ 37% organic substrate and 58% moisture content with an initial heating value of 2,889 kcal/kg; and Experiment B ‒ 28% organic substrate and 35% moisture content with an initial heating value of 4,174 kcal/kg. The bio-drying was performed in both experiments under negative ventilation mode and non-ventilation mode, the ventilation mode was set at the aeration rates of 0.2 m3/kg/day and 0.4 m3/kg/day. The results suggest that the optimum aeration rate was 0.4 m3/kg/day, achieving a 30% moisture reduction and a 60% heating value increase from their initial values. As a result, the improved wet-RDF qualified for the local cement industry’s standard in terms of heating value.Keywords
Funding Information
- National Research Council of Thailand
This publication has 21 references indexed in Scilit:
- Biodrying process: A sustainable technology for treatment of municipal solid waste with high moisture contentWaste Management, 2016
- Forecasting of municipal solid waste quantity in a developing country using multivariate grey modelsWaste Management, 2015
- Simulation of water removal process and optimization of aeration strategy in sewage sludge compostingBioresource Technology, 2014
- The feasibility of converting solid waste into refuse-derived fuel 5 via mechanical biological treatment processJournal of Material Cycles and Waste Management, 2013
- Combined Heat and Power from Municipal Solid Waste: Current Status and Issues in South KoreaEnergies, 2012
- Effects of biodrying process on municipal solid waste propertiesBioresource Technology, 2011
- Reject management from a Mechanical Biological Treatment plant in Bangkok, ThailandResources, Conservation and Recycling, 2011
- Effect of air-flow rate and turning frequency on bio-drying of dewatered sludgeWater Research, 2010
- Biodrying for mechanical–biological treatment of wastes: A review of process science and engineeringBioresource Technology, 2009
- Bio-drying of municipal solid waste with high water content by aeration procedures regulation and inoculationBioresource Technology, 2008