Performance of a Combined Hot‐Air–Infrared Hybrid Convective Dryer for Zucchini Slices
- 17 July 2025
- journal article
- Published by Wiley in Heat Transfer
- Vol. 54 (7) , 4735-4744
Abstract
Drying is one of the most popular methods used in the food industry to reduce postharvest losses, extend shelf life, add value, and reduce handling. However, conventional drying methods such as hot‐air (HA) dryers are time‐consuming, energy‐intensive, and can affect the food quality. To address these challenges, infrared (IR) drying has been added as a booster heat source, ensuring faster drying, energy saving, and quality improvement, since each method has its limitations. Therefore, combining HA and IR drying has been shown to be a more efficient technique, ensuring better drying performance. The aim of this study is to design and test the performance of using the HA and IR hybrid dryer for drying zucchini, by evaluating the zucchini quality attributes, such as moisture content (MC), water activity, rehydration ratio (RR), and shrinkage in diameter. In this study, different samples of zucchini slices were dried in a hybrid dryer under three different combinations of heat air and air speed, selected based on preliminary trials, including IR2‐S1‐H2, IR2‐S2‐H2, and IR2‐S2‐H1, where IR2 refers to the use of two IR tubes, S refers to the air speed and H indicates the heater level. The physicochemical properties of dried zucchini samples were analyzed and compared, including MC, moisture ratio, drying rate, water activity, rehydration, and diameter shrinkage. The results showed that IR2‐S2‐H2 was the fastest among the three drying combinations, reaching 10% MC within 40 min, while IR2‐S1‐H2 and IR2‐S2‐H1 required 60 and 80 min, respectively. The Midilli–Kucuk model offered the best‐fit model for the MC data of IR2‐S1‐H2 and IR2‐S1‐H1 (R2 = 0.9999 and 0.9999, RMSE = 1.6340 × 10⁻⁶ and 0.0011, respectively), while the logarithmic model provided the best‐fit model for IR2‐S2‐H2 (R2 = 0.9999, RMSE = 1.5421 × 10⁻⁷). All dryer combinations resulted in an RR of 4.67–5.80, and the water activity of dried zucchini samples was within the recommended food safety threshold (water activity = 0.207–0.411 < 0.6). In addition, the lowest diameter shrinkage (28.21%) was observed with the IR2‐S2‐H1 condition. This study recommends further research to optimize drying parameters and improve food quality as well as to evaluate the application of this dryer to other fruits and vegetables.Keywords
This publication has 39 references indexed in Scilit:
- Experimental performance analysis of an infrared heating system for continuous applications of dryingCase Studies in Thermal Engineering, 2024
- Investigation of microwave application time with constant pulse ratio on drying of zucchiniFood Science & Nutrition, 2023
- Three-dimensional morphological changes of potato slices during the drying processCurrent Research in Food Science, 2021
- Influence of drying temperature on anthocyanin and moisture contents in purple waxy corn kernel using a tunnel dryerCase Studies in Thermal Engineering, 2021
- Investigation of ultrasound-assisted convective drying process on quality characteristics and drying kinetics of zucchini slicesHeat and Mass Transfer, 2019
- Drying characteristics of zucchini slices under periodic infrared-microwave vacuum conditionsHeat and Mass Transfer, 2017
- Hot air drying of apple slices: dehydration characteristics and quality assessmentHeat and Mass Transfer, 2015
- Drying of shiitake mushroom by combining freeze-drying and mid-infrared radiationFood and Bioproducts Processing, 2015
- Drying of chilli in a combined infrared and hot air rotary dryerJournal of Food Science and Technology, 2014
- Influence of drying temperature on dietary fibre, rehydration properties, texture and microstructure of Cape gooseberry (Physalis peruviana L.)Journal of Food Science and Technology, 2013