Modeling and Design of Experiments of Laser Cladding Process by Genetic Programming and Nondominated Sorting
- 16 October 2014
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 30 (4) , 458-463
Abstract
Laser deposition of materials represents a modern additive technology that has a number of advantages over remaining technologies for depositing metallic materials. Besides a low-energy input, a quality bond, and minimal heat-affected zone, this technology is also characterized by the good mechanical properties of the deposited material that is a result of rapid cooling. Despite the prospects, this technology is still at the developing phase. New materials and techniques for determining optimal process parameters are being introduced. In this article, we developed a system for modeling (predicting) the properties of the deposited material and used design of experiments (DOE) for the laser cladding process parameter selection. Based on the experimental data obtained during cladding process, models were made for predicting the volume and roughness of the deposited material. Genetic programming was used for modeling the process. Then, a set of several thousand possible combinations (settings) of the machine parameters was produced on the basis of the obtained model. The most appropriate machine (process) parameters were selected in terms of deposition speed, powder efficiency, and surface roughness. These parameters were determined by nondominated sorting. The results offer the operator of the machine a set of appropriate process parameters that enable the production of high-quality products.Keywords
This publication has 22 references indexed in Scilit:
- Laser Deposition of Ti-6Al-4V Wire with WC Powder for Functionally Graded ComponentsMaterials and Manufacturing Processes, 2013
- Laser deposition of Metco 15E, Colmony 88 and VIM CRU 20 powders on cast iron and low carbon steelThe International Journal of Advanced Manufacturing Technology, 2012
- Blanking punch life improvement by laser claddingEngineering Failure Analysis, 2011
- Numerical simulation of thermal behavior during laser metal deposition shapingTransactions of Nonferrous Metals Society of China, 2008
- Compositionally graded yttria-stabilized zirconia coating on stainless steel using laser engineered net shaping (LENS™)Scripta Materialia, 2007
- Compositionally Graded Aluminum Oxide Coatings on Stainless Steel Using Laser ProcessingJournal of the American Ceramic Society, 2007
- Analysis of thermal phenomena in LENS™ depositionMaterials Science and Engineering: A, 2006
- Comparison between diode laser and TIG cladding of Co-based alloys on the SUS403 stainless steelSurface and Coatings Technology, 2006
- Thermal process maps for predicting solidification microstructure in laser fabrication of thin-wall structuresJournal of Materials Processing Technology, 2006
- Numerical modeling of the thermal behavior during the LENS® processMaterials Science and Engineering: A, 2006