Failure-Mode Analysis and Protection of Three-Level Neutral-Point-Clamped PWM Voltage Source Converters
Authors:
- 15 January 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 46 (2) , 866-874
Abstract
This paper presents the detection and protection methods uniquely associated with three-level neutral-point-clamped voltage source converters. The line-to-ground fault can cause significant dc-link neutral voltage and can therefore be effectively detected and located through monitoring the dc-link midpoint voltage without extra hardware. The inner device short in the three-level phase leg can lead to dc-link voltage imbalance and doubling the stress on capacitors and devices, which must be suppressed for the safe operation of the converter. Two overvoltage-limiting methods are proposed to limit the overvoltage. The design of both ground fault detection and overvoltage limiting has been covered in the paper. The schemes are verified through simulation and experiments.Keywords
This publication has 15 references indexed in Scilit:
- Faults analysis and remedial strategies in high power neutral point clamped converters2008 IEEE Power Electronics Specialists Conference, 2008
- Strategies of fault tolerant operation for three-level PWM invertersIEEE Transactions on Power Electronics, 2006
- Detection and compensation of switch faults in a three level inverter2006
- High-Power Regenerative Converter for Ore Transportation Under Failure ConditionsIEEE Transactions on Industry Applications, 2005
- A reliable, interface-friendly medium voltage drive based on the robust IGCT and DTC technologies2003
- Fault protection in a multilevel inverter implementation of a static condenser2002
- Design of a fault tolerant control system for a NPC multilevel inverter2002
- Grounding of AC and DC low-voltage and medium-voltage drive systemsIEEE Transactions on Industry Applications, 1998
- Investigation of fault modes of voltage-fed inverter system for induction motor driveIEEE Transactions on Industry Applications, 1994
- A New Neutral-Point-Clamped PWM InverterIEEE Transactions on Industry Applications, 1981