The effect of geometrical parameters on the flow field of an opposed jet rim mix head: Equal flow and matched fluids
- 1 February 1996
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 74 (1) , 40-48
Abstract
The effect of geometrical parameters on the flow field present in the mix head used in reaction injection molding (RIM) are presented for Red (Red = 4Q/πdv, nozzle diameter d, fluid kinematic viscosity v and the volumetric flow rate Q through the nozzle) representative of commercial practice. Quantitative velocity measurements of the flow field in a mix head have not been reported in the literature despite the extensive use of the mix head for reaction injection molding. Flow visualization and velocity measurements using a laser Doppler anemometer have been obtained for different values of geometrical parameters such as mix chamber diameter (D), distance from the nozzle inlet to the closed end of the chamber (H), and nozzle needle position (N). The ratio of the mix chamber to nozzle diameter (d) (D* = D/d) was a significant parameter affecting the flow field. The distance from the impingement point to the closed end of the chamber was found to have little effect on the observed flow field beyond the impingement area. A nozzle needle position that partially constricted the nozzle opening was found to decrease the axial distance to unidirectional flow within the mix chamber.Keywords
This publication has 11 references indexed in Scilit:
- A Numerical Study of Laminar 90-Degree Bend Duct Flow With Different Discretization SchemesJournal of Fluids Engineering, 1991
- Experimental and theoretical investigations of turbulent flow in a side-inlet rectangular conbustorJournal of Propulsion and Power, 1990
- ROLE OF UNDERRELAXATION IN MOMENTUM INTERPOLATION FOR CALCULATION OF FLOW WITH NONSTAGGERED GRIDSNumerical Heat Transfer, 1988
- A study of finite difference approximations to steady-state, convection-dominated flow problemsJournal of Computational Physics, 1985
- Investigation of a dual inlet side dump combustor using liquid fuel injectionJournal of Propulsion and Power, 1985
- ENHANCEMENTS OF THE SIMPLE METHOD FOR PREDICTING INCOMPRESSIBLE FLUID FLOWSNumerical Heat Transfer, 1984
- Numerical study of the turbulent flow past an airfoil with trailing edge separationAIAA Journal, 1983
- Impingement mixing in reaction injection moldingPolymer Engineering & Science, 1980
- Mixing for reaction injection molding. I. Impingement mixing of liquidsPolymer Engineering & Science, 1980
- A stable and accurate convective modelling procedure based on quadratic upstream interpolationComputer Methods in Applied Mechanics and Engineering, 1979